Zynq-7000 PCB Build - Part 6 - HDMI (initial pass at least)

Sdílet
Vložit
  • čas přidán 28. 04. 2024
  • I started the HDMI connections. I have more reading and research to do for these HDMI connections, I think. www.rehsdonline.com/post/xili...

Komentáře • 6

  • @asmi06
    @asmi06 Před měsícem +1

    Also during component placement remember that PCB has two sides, and not just one.

  • @asmi06
    @asmi06 Před měsícem +3

    HDMI *requires* pull-ups, and no, diodes are not pull-ups. The reason datasheet doesn't show them is that often HDMI ports of a SoC have them integrated internally. But since you use a general purpose IO pins (as opposed to dedicated ones, which is usually the case for SoC), they don't have integrated pull-ups, and therefore, you need to have external ones. Unless you use some kind of active component like retimer or signal conditioning IC - for example TDMS141, which is what I like to use - these often have internal termination resistors as well.

    • @rehsd
      @rehsd  Před měsícem

      Thank you for those details! I'll get pull-ups put back in.

  • @asmi06
    @asmi06 Před měsícem +2

    Your HDMI connectors are way too close - no way you'd be able to connect cables to both of them at the same time.

    • @rehsd
      @rehsd  Před měsícem

      In the next week or two, I will measure things out more thoroughly, and consider the bottom side of the PCB for placement of components. I imagine once I start looking at actual routing, I'll want to shift things around yet, too. Thanks!