Video není dostupné.
Omlouváme se.
Do Not Place APs Above The Ceiling
Vložit
- čas přidán 17. 08. 2024
- Read the full post here: www.wlanpros.c...
Do not put your access points above the ceiling tiles
In today's rules for efficient Wireless Lan design, we're going to talk about why you should not put your access points above the ceiling tiles
Chapters:
00:00 Start
02:19 Why Is my client device receiving changeable RSSI?
04:02 What happens if we put the AP above the ceiling tile?
04:47 What else is above the ceiling tile that may interfere with your RF?
06:02 Tips
I don't even need to know any of this. This guy just explains stuff so well I just love watching them and learning fun stuff.
Great video once again. To avoid above the ceiling AP's I tell the architects, bosses and so forth that I cant troubleshoot without being able to watch the LED's on the AP. Technically not the whole truth about troubleshooting Wi-Fi. But it works.
Genious response
Ceiling tiles are thermal insulators, and most APs are designed to be passively cooled. It is easy to run into overheating issues when the APs are above the ceiling.
thank you for the great video Keith
Excellent, to the client i will sugges to put it correctly as it is easier for troubleshooting and better avoiding some attenuation and bounces from materials above the ceiling that could affect the performance.
Good tip!
If you put the APs (WAPS) above the ceilings, the farads running around on top of the tiles will chew through the patch cables.
A few months ago, I mounted an AP on the bottom side of an air duct for a similar reason. If I had mounted it on the ceiling (no drop ceiling), there would have been air ducts between the AP and part of the coverage area.
Great Video ....
Thank you Keith!
But if i have two floor Is impossible respect this rule,what do you think?
The only thing worse than putting APs above the ceiling tiles is people putting Microphones above the ceiling tiles.
Surprising people are so stupid as to request this installation. Then again, perhaps not so surprising. Some multipath is needed from what I understand, but not too much. MIMO relies on it from what I understand.