Hobao Hyper MT Nitro With LRP ZR28 Spec4 Engine and Gearbox Tuning

In this video I am trying to get the truck to run well and go into 2nd gear.
Once the engine fully gets upto temp it seems to run a bit leaner, so i richen the HSN.
The shift point for 2nd gear was also a little late and required it to be screaming or going down hill to shift, so i have set it to shift earlier.
Also i was checking temps throughout the run. With the current tune and the body off the engine runs at 98c, with the body on it can get upto 120c, so i am going to drill some holes in the shell to improve airflow. I want the engine to run around 110c.

[@garyfaulk8053]

Nice truck, I am thinking about getting one myself, if don’t mind what is the cost for your truck

[@LawrenceTimme]

I think it was £440 for the truck. Don't remember how much it was with all the upgrades. Probably around £600

[@RCAddictsGarage]

On point!💥💨

[@tbrickrc7085]

Sounds good

[@erdoganog]

Do you know the factory settings? For the set screw on the trans or how many turns out do you have yours at

[@LawrenceTimme]

Not a clue.

[@AlexBongRCFunLand]

is this .28 engine perform better then the original Hyper30? in term of acceleration n torque? will it easy to wheelie the MT?

[@LawrenceTimme]

No. Unfortunately I think the standard engine might have been better.

[@denisdenis2034]

your mixture is not too lean but too rich on this video

[@narongrachmareongsit1978]

❤🎉😮😊ไฟไฟกำ