part 3 Toro timemaster installing blade engage cable

In part 2, we installed a blade engagement cable. And I also went through the carburetor as I noticed some surging, but I did find water in the fuel. but it's still got the surging but not under load
link to part 2 if you haven't seen it
• part 2 toro time maste...

[@gravelyman]

Hello John. I'm hoping the crankshaft isn't out of balance using that engine. I hope it's just a carb issue. Good luck my friend. Mom wants you to get going with that push mower repair LOL 😂. Sending prayers to your Mom and Dad 🙏🔧👍

[@Turningwrenches85]

Part 4 I finally got it figured out I think and we take it on a test mow in the front yard , yes I had a friend looking for a mower 😅 thanks for the prayers 🙏🏻 brother 🔧

[@dfields9511]

49:37 thats sweet sound there🤙

[@Turningwrenches85]

Yes it did, not bad swap 😉

[@rogermcdonald1607]

John the engine should idle smoothly and the RPM increases when engaging the blade handle. So far your not into it that much with the 2 cables but that blade belt is very pricey if you have to replace it. After your done cleaning and shining it up, you should make some good 💸💸. Goodluck! 👍🇺🇸

[@Turningwrenches85]

Next video I got it running better and also lucky the timing belt for the blades is still in good shape on it also did some test mowing :)

[@robertmailhos8159]

The engagement of the blade to the engagement Cable I now pronounce those 2 as being able to cut the grass

[@Turningwrenches85]

Yes sir 👏

[@tinkeringtaylor3053]

You done well on that John, it shouldn't surge on idle, see how it runs without the air filter then if the same put the original fuel tank on that come off that engine without the foam inside, and try a new fuel filter old one could be contaminated with water 🤔

[@Turningwrenches85]

Thank you sir In the next video, I got it running better , I did switch out the fuel filter, and I had to turn in the screw on the carb to get it, not to surge. It's been better since I do need another air fliter for it but it's been running good .

[@tinkeringtaylor3053]

@@Turningwrenches85 nice one John, look forward to the next video 👍

[@INSIDEHOUSEGARAGE]

keep running and see if it'll clear itself

[@Turningwrenches85]

Next video I got it running better had to tweak the screw on the carburetor to keep the idle from moving