ENNOID XLITE V3 Smart BMS Setup & Configuration
Vložit
- čas přidán 27. 07. 2024
- If this information has been helpful for you, please consider supporting the channel:
theboardgarage.com/store
/ theboardgarage
Follow me at:
/ theboardgaragellc
/ theboardgarage
00:00 - Introduction
01:34 - Waking the BMS up
03:10 - Connecting to Bluetooth
04:04 - General & Pack Configuration Explained
06:52 - Cells Limits
09:54 - Temperature Limits & Temp Sensors Explained
14:05 - Balancing
14:38 - Sleep
15:26 - Finishing Up & Checking
17:06 - Test Charge & Checking Charger - Věda a technologie
Once again, filling my library with such valuable information, thank you.
Great video Mario, thank you
Thank you for this video!
Very helpful, thanks! Two hopefully quick questions. 1) Are the cell limits you show also appropriate for 18650 cells / a speed pack? 2) Can the humidity reading from the Ennoid be used as a diagnostic for water ingress, and if so what reading would indicate water ingress vs. just high humidity air coming through the gore tex vent?
Love your videos! Super hype for my first battery from you
Great video! Very informative as always! I love my V3, and I have to say I couldn’t ever run a “Dumb BMS”. Not being able to see voltage or temps would bug me to no end.
Also, firmware 6.2 is out now!
is it possible to save cell data during a discharge?
Thanks for the video - useful info in there! Could you provide detail on the 'Signal' menu? I can see how 'Charger Voltage Factor' could be used to calibrate voltage readout by the Ennoid but unsure what the 'Shunt Factor', 'NTC 25 Degree' and 'NTC Beta' values are used for? Many thanks!
Is there any hope for my toyRus Neon Nitro battery replacement and software upgrade..? Max speed dead stop feature seems monumentally stupid..
I have that setup and sometimes when I plug in the charger after I’m back home it won’t charge unless I turn off the board. What could be the reason?
In some cases, the software won’t allow the operational state to change to ‘charging’, if it’s in a power down mode or something along those lines. I believe that’s been mostly resolved in the recent firmware release. I’m not sure.
And that would also explain that it only happens sometimes not always ?
WTF is that thumbnail... red circle and arrow for no reason 🤣
Just having some fun, no real point there.
@@TheBoardGarage hilarious, i love it