Lessons Learned & Common Issues After Three Years Of Using The Trident | How I Fixed Them
Vložit
- čas přidán 26. 08. 2024
- 🔴Purchase Corals From My 300 Gallon Reef: fishofhex.com
🔴My Personal NO3 & PO4: fishofhex.com/...
🔴3D Printed Items: fishofhex.com/...
🔴Purchasing A TShirt: teespring.com/...
🔴Come Join Our Discord / discord
🔴Instagram: / fishofhex
🔴Become a supporting member and be added to the scrolling credits: / @fishofhex
🐠FishOfHex Sponsors🐠
🚩CustomAquariums www.customaqua...
🚩Geosreef www.geosreef.com/
****************Popular Playlist****************
🐟Beginner Guide Playlist: • Beginner Guide To Salt...
🐟Quarantine Tank: • Quarantine Tank
🐟300 Gallon Reef Playlist: • 300 Gallon Reef Tank B...
🐟30 Gallon Triton Method Build: • Nuvo Micro 30 | Cheato...
🐟Fish Room Playlist: • Fish Room
🐟125 Gallon Reef Playlist: • 125 Gallon Reef Tank
🐟Subscriber Q@A: • Subscriber Q @ A
🐟How To Playlist: • How To & DIY
🐟Neptune Apex Playlist: • Neptune Apex Controller
🐟Tips & Tricks Playlist: • Playlist
End Music: www.bensound.com
Thank you for watching the video, if you want to support the channel head over to fishohex.com
15p frag pack $345 with free shipping: fishofhex.com/collections/frag-packs/products/15-piece-frag-pack
Buy 3 get 1 free on 3D Printing/ Free shipping over $80
I found it much easier to disassemble the unit and clean the reaction chamber with some alcohol and a Q-tip!
Agreed needle guides are a must, not sure why Neptune didn’t think of them.
Also ABC reagents are a great alternative to official Neptune reagents at a fraction of the cost.
I leave the cap off of my BRS slim jug to help evaporate the waste water. I also put a nano tank sized filter sock in my sump and placed my sample line inside the sock. No problems with clogs/micro-bubbles. Use can use a sock, filter bag, etc and mount in your sump with a clip, magnet, etc. This would probably work well for placing a salinity probe also.
I bought a Trident new in October of 2022. Didn't unpack and use it until end of December 2022. It was consistently off by 1dkh lower on Alk than the Hanna. So that was ok, just so I had a correct range no big deal. Then, about 4 months in, it went haywire. Alk, Cal, Mag readings were all way off. Cal would say 322 and Hanna was saying 465.
I went through 2 months of Neptune support and I did clean the testing vial about 3 months in. Support was turtle slow. I keep my equipment in like new condition always as I'm a stickler for that stuff. They sent me what they said was a new Trident. It came with broken pieces in the shipping box, plenty of extra cat hairs to use 😂, and was beat up. I told them that wasn't going to work and they finally shipped me a wrapped brand new Trident.
I sit here contemplating about whether to open it and use it or sell it. I have 2 of the DOS doses and 2 of the DDS containers that are brand new that I haven't been able to use because of issues.
I'll probably bite the bullet and try again as if I can keep it working, it's well worth the money. Look at the Alkalinity testers that test that one parameter. They're 800, 1200, etc. There isn't a lot of options for a tester that does all 3. I would love to have one that does Alk, PO4, and NO3. Cal and Mag don't change that often and I have all the Hanna testers.
Thanks for the video on this and I guess I'll get to install the new one today.
Hey champ, have a look into a power factor corrected power supply to replace all the power bricks. Not only will a larger coil driven transformer give you far better conversion efficiency, it will also drastically reduce the charge/cost for the load as these style of power bricks cause you to be be charged for electricity you are not actually using. We are probably talking anywhere from a 30% to 60% saving in power consumption charged.
Where can you get those?
Is there a way to swap out the lines for ones more sturdier or thicker? Maybe just the waste line ? Could you maybe upload a maintenance video on the trident system please ? Or do you have a link for one?
Have you tried abc reagents? It’s a lot cheaper & does the same job! 😊
Hello
Good video!!
Do you got the same readings like the hanna checker
Has anyone tested the calibration solutions? It’s not what the bottles claim it is.
But why does it try to tell me the discord Link doesn't work
The best way I have found to take care of the trident is throw it in the garbage. Had mine less than 6 months and wouldn’t add reagent. After talking with them decided not to throw good money after bad and broke the Hanna’s out. Save the $600 and dip your finger in and taste the aquarium water, just as good.
After calibration test having problems reading alk proper my hanna says 9.1 but trident say 8.45 then goes down to 7.9 next day
The trident is junk imo.