One beep is an oil signal, the factory flaw of all 2021 models (so it works from day one until now and has 5200km), and 3 beeping is a signal for high revs (max in red).
@@vanjavinceljak9159 open the display cover and disconnect the alarm :) you will gett notice on display if anything is wrong anyway so no need for the alarm.
I have a 2021 cforce 800 xc mine did beep off and on when breaking in but the rpm was not stable at idle. it doesn’t do it anymore only when you first start it. I am thinking your RPM is too low mine runs at 1400 warm up or you need a new oil pressure switch.
@@DCSPORTSTER Mine works the same at 1400 rpm, only works beep when I go downhill, stopped on the downhill put in N and added throttle and all the same worked beep .. I was told at the service that the sensor runs out of oil and that's why it signals. They say they fixed it on the new CF Overland 1000 models.
Priroda je 😍 super vožnja
Muuuito top a trilha. Parabéns
Obrigada
sa stotkom po njivama opali samo pravo sva cast decki!!
wow.. best atv video on yt
Hvala 🙂
Please tell us your 1 year experience about CF1000. Worth it? What was the problems? How much you spend for it? THank you!
hello, what can you say positive about cforce and about the shortcomings?
Odličan video, gdje je ovo snimano?
Hvala, Hrvatsko zagorje, okolica Krapine
You need to send your atv to the shop and they send the dash board to the factory to get that beeping out . I did it with mine.
I took out the speaker today so there will be no more of that annoying sound .
@@vanjavinceljak9159 did you get your electric power steering replaced with the recall?
@@juliopena21 I did and it's much better now. They installed a new electrical installation for EPS.
Pozz brate. Da li je i koliko velika razlika iymedju 520 i 625
Nije neka razlika u snazi nego kolko je 625 udobniji za voziti i ljepse izgleda
👍
what is the name of this navigation?
OsmAnd
What's that beeping noise? I hate it 😂
What´s that beeping noise?
One beep is an oil signal, the factory flaw of all 2021 models (so it works from day one until now and has 5200km), and 3 beeping is a signal for high revs (max in red).
@@vanjavinceljak9159 open the display cover and disconnect the alarm :) you will gett notice on display if anything is wrong anyway so no need for the alarm.
I have a 2021 cforce 800 xc mine did beep off and on when breaking in but the rpm was not stable at idle. it doesn’t do it anymore only when you first start it. I am thinking your RPM is too low mine runs at 1400 warm up or you need a new oil pressure switch.
@@Kurti83_ ok .. i've been thinking about doing this for a long time.
@@DCSPORTSTER Mine works the same at 1400 rpm, only works beep when I go downhill, stopped on the downhill put in N and added throttle and all the same worked beep .. I was told at the service that the sensor runs out of oil and that's why it signals. They say they fixed it on the new CF Overland 1000 models.
Das Gepiepe ist nervig