How to make JDM turn signals

UPDATE: I recommend using a UV resistant clear coat and/or ceramic coating after the paint has cured.
*Also, it’s come to my attention that this particular spray tint has become hard to find. My method in the video should work with any type of orange spray tint.
*CHECK YOUR LOCAL LAWS BEFORE ATTEMPTING
I'm not responsible for any damage done to your vehicle. This video is for entertainment purposes only.
Sorry for out of focus and uncentered video clips, as well as jumpy editing.
Steps:
-Remove turn signal
-Sand turn signal with 600 grit sandpaper
-Clean turn signal
-Tape off turn signal
-Apply a light coat of the tint. Wait about 2 minutes. Repeat until desired look is achieved.
-Apply 2 coats of clear coat with 2 minutes between each coat.
-Install once fully dry
I don't recommend tinting the inside of the light. It can result in a poor looking finish.
This is not a sponsored video.
As always, constructive criticism is welcomed and encouraged. I'll take hate too if thats all you got.