How to Replace the Rear Light Unit on a Toyota Yaris

How to remove and replace the rear light unit in a 1999 to 2005 Toyota Yaris. Thanks for watching. Please comment, like and subscribe !.
All of my uploaded material is protected under copyright law. None of my videos may be re-uploaded, reproduced or transmitted, in part or in full, in any form or by any means, without the written permission of the copyright holder.
© / screwsnutsandbolts 2020
Read important information below:
Disclaimer:
Due to factors beyond the control of Screwsnutsandbolts, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. Screwsnutsandbolts assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Screwsnutsandbolts recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of Screwsnutsandbolts, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not Screwsnutsandbolts.

[@Marten99-qb5yk]

After changing the rear light, water got into the light. So I had to remove it again to fix the problem . I dried it and resealed it with bathroom silicone.

[@victorojeda1544]

Excelent explanation , very good ,

[@screwsnutsandbolts]

Thank you !

[@laniepapa8141]

Very helpful! Thanks!!

[@screwsnutsandbolts]

You're very welcome !

[@raulvibo]

Great video! Thanks!

[@screwsnutsandbolts]

You're welcome !

[@nadim2769]

Planning on fitting reversing sensors to mine soon so thanks, helps me out 👍🏽. But how does that one bolt hold the tail light in place? Seems insecure imo

[@90210dk1]

Great video thankyou..

[@screwsnutsandbolts]

Thanks for watching ! :)

[@AA-os1sg]

If any of you ever have a problem with tail light fuse 7.5amp blowing continuously. Fuse is located drivers side under the steering wheel. Its most likely rear corroded light bulb socket. Water is known to get past the seal sits in the light casing over time & rots the plug causing a mysterious problem. Remove the light 10mm nut & reseal it. Hope my experience helps somebody! Before you call out an auto electrician. Otherwise brilliant motor!

[@screwsnutsandbolts]

Thanks for the advice :)

[@takeadrive]

Very good

[@screwsnutsandbolts]

Thanks !

[@motorlistrikeveryday]

thank you

[@screwsnutsandbolts]

You're welcome !

[@sf8055]

Ive got 2003 yaris, but the wires plug into a separate attachment to the sockets, not like this

[@huzaifabaig5522]

Bro how to remove the glass cover can u plzz tell

[@thesimplyteez]

Is this the same procedure for the Yaris hatchback tail lights?

[@screwsnutsandbolts]

This is 2000 Yaris Hatchback.

[@oscarhetakmusic]

Would you recommend to use any sealant when putting it back to stop from leaking? If yes what kind of seal?

[@screwsnutsandbolts]

I don't think it's necessary if the rubber seal is in good condition :)

[@oscarhetakmusic]

@@screwsnutsandbolts unfortunately it isn’t in best condition. Just wondering how I could replace it

[@oscarzapata7192]

@@oscarhetakmusic any rubber type sealant like the ones u used on the transmission carter

[@aidanas9890]

I was thinking the same, my lights has accumulated about half a pint of water , which in turn had destroyed one of my bulb holder with rust. I have tipped the water out and am considered loads of bathroom silicone when the new bulb holder arrives. The existing seal is in poor condition and a section has broken off.

[@user-eg8qw1fw4n]

صح

[@jennywong8581]

How to fix horn 2011 Yaris

[@screwsnutsandbolts]

I haven't worked on that model Yaris so I don't know, sorry