Gemmy factory error 2 song

Sdílet
Vložit
  • čas přidán 11. 06. 2024
  • Got him for around $50-65. He arrived in terrible condition. He only has 1 snowflake. The spinning knob was snapped, the back lever was snapped and still is for now ill have to use copper wire to fix it. I had an extra spinning knob to fix it. The neck piece is snapped where the hat arm goes into place so it goes over the head for now until i replace it with the other one i have. A-lot of things were snapped. Seller fault? I don’t know. He did say the hips and hat did not work. (Which they didn’t but the spinning arm didn’t work even though he said it did.) The hat had no 8 tooth it was just gone. Miraculously the square shaft wasn’t split. The hips had a missing tooth on the 10 tooth which i replaced and a snapped in half square shaft. I used super gel glue for the first layer, then poured a bit of baking soda on it, and then put a layer of liquid super glue on-top. Then i did the same for the bottom and removed the excess because it would prevent it from spinning and just snap again. He looks like a 1 song, demo port on side like a 1 song, 1 song body, 1 songs have the foam circles that go around the screws on the bottom which he has. He has an unsewn vest like a 2 song and a sticker in the spot where the 2 song stickers are. He also has this board factory error too where it makes a beep sound when saying: “I’m too much!”. The spinning arm has a split gear that is have not fixed yet. Very weird guy but also cool.

Komentáře • 12