thanks for sharing relevant scenario close to production setup. Make video on production multicast scenario which is being used in iptv service or in DNS service providers.
Local Preference ISP1 routes @21:49 & 33:12 , Pre-pend ISP1 to select R1 for subnet 11 @29:10, Pre-pend ISP2 for R2 @33:39, Local Preference for ISP2 @39:22
I think there is some configuration issue here both R1 and R2 default route next hop should be ISP A then the traffic other from AS 200 and AS 300 will go out from ISP 1
BGP is ideal to be used on Load sharing , static routing might achieve that however that is not practical/recommended specifically in large network setup
Thanks for your time on sharing this information.
Very Good Explanation..
Good explanation.. Thanks buddy
thanks for sharing relevant scenario close to production setup. Make video on production multicast scenario which is being used in iptv service or in DNS service providers.
Thanks Bro....semma useful.
Local Preference ISP1 routes @21:49 & 33:12 , Pre-pend ISP1 to select R1 for subnet 11 @29:10, Pre-pend ISP2 for R2 @33:39, Local Preference for ISP2 @39:22
How can we configure same setup on Juniper MX routers?
Why IBGP through a switch and not do a direct link from R1 to R2??
very good
ASA200 should send default route to ASA 100 ....how did you achieve it..i cannot see any access list or route map..to influence traffic
I want to implement dual isp load sharing but my knowledge limited. (I never have known BGP before)
sir what will be configuration if I have both isp links on R1 and want to reach at R5 (aspect R5 is a cloud router ) with equal load balancing
Give maximum path 2 in bgp configuration
I think there is some configuration issue here both R1 and R2 default route next hop should be ISP A then the traffic other from AS 200 and AS 300 will go out from ISP 1
Tarun Arora agree
you have not advertised route 155.x.x.x from both ISP1 and ISP2
Can you create a failover video for the same
ebgp multi-hop 2 command needs to be there between ebgp peers
no need to give ebgp multihop command here neighborship is not built from loopback ip
Scenario is great just like production but explanation is not proper
Audio is very low.
can I configure load sharing without BGP sir?
BGP is ideal to be used on Load sharing , static routing might achieve that however that is not practical/recommended specifically in large network setup
Sandeep bhai too boring sessions