Peel thoroughly. How to Fix Shaking drill head properly

#FatihKreasi #BorRyu # RyuRID13 #ImpactDrill
Hi friends ...
meet again on our channel Fatih kreasi ..
In this video, Fatih Kreasi will thoroughly discuss the problem of the Ryu RID 13-1 RE impact drill that occurs on the drill head or the chuck often shakes, making it difficult to take the center object to be drilled.
Previously, Fatih Kreasi will explain the reasons why this happens so often. To be honest, this doesn't only apply to this one brand, which just happens to be the RYU brand in the video. All drills will experience the same thing that is due to wear and tear.
1. In general, impact drills are used in tough work such as drilling in concrete when drilling for hand strength that presses or pushes the drill on one of the causes because of a momentary force on the machine to change the position of the chassis, this is only natural, anyway ,, the solution is to fix there
2. Drilling that is not straight or doing sloping drilling, causing friction with the axle until the axle runs out, the chuck head shakes.
For more details on how to solve the shaky drill head can be seen in the video, please watch it completely, friend, so that when practicing it does not fail.
The bearings used as an alternative to the Bosh in this video are the 607zz type as two bearings. the specific size is adjusted to the following sizes:
1. Inner diameter of 6.8 mm
2. Outer diameter 9.5mm
3. 10-11mm thickness
For those of you who experience the same case, if you are looking for a bosh on the market, please measure your needs first by measuring directly on the engine (axle) chuck and impact because the size of the manufacturer is likely to change due to erosion and loss of the iron material during use.
Here's a list of impact drills with the same specifications as this video:
- Maktec MT 80b
- Stanley SDH600K
- Dewalt DWD024
- Makita HP1630
- Bosch GSB 550
- Doliz BA670
- Jld 13-5
- Mailtank SH09 13
- NrtPro 500 HD
- OSSEL BT 080
- ATS BT-13
- Orion HD600P HD-6617
and the possibility of these people experiencing the same thing, namely the drill head is shaky or unstable.
Don't forget my friend, comment, like and subscribe.
Thank you :)
here I have a bearing that is suitable for use as bosh as a material. we should try directly on the axle
That's the end of this video,
if there are additional from colleagues or friends to patch the shortcomings, please leave them in the comments column. Don't forget to support it for likes and subscribers. thank you
asalammualaikum warahmatullahiwabarakatu ..