this is really a good smoke generator design with the internal plate to ensure that smoke moves freely what i am going to do is make a bottom mechanism to remove the ash whilst in operation and have the option to add more chips for long haul smoking
How do you manage moisture which ALWAYS condensate from smoke in the upper chamber portion and falling down is soaking the chips thus at some point the smoker stops working?
Brilliant idea.. Have you tried to run it with the pipes on the bottom (upside down compared to this orientation)? It's the main difference between Bella Smokin It and the Big Daddy smoker. A CZcamsr showed the Bella Smokin it to be more precise. Also, can you provide a part list for ease of replication?
Have you done a temperature check with the cold smoker generator inside a closed smoker? If so, did the temperature inside increase, as the air flow from the smoke generator increased and vice versa? If would seem the greater the air flow, the more chips that would burn greater and faster; creating additional smoke as well as heat. I know I have better luck cold smoking if can keep the temperature below 85 degrees. A great design idea for cold smoking.
This design is way better than the smoke daddy. I have a smoke daddy and the coiled wire in the middle is a poor design. This design it is impossible to clog up.
Just I don't get the smoke out. Works for a few minutes and than ? Finished, nothing happening again. I check it out x times x and I don't know what I'm doing wrong. Any idea about? Help very appreciate 🙏
I like the air channel you have put into the build..
great design! I've been working on something similar for my smoker.
Brilliant idea, well done thanks for sharing.
this is really a good smoke generator design with the internal plate to ensure that smoke moves freely what i am going to do is make a bottom mechanism to remove the ash whilst in operation and have the option to add more chips for long haul smoking
Really great job, an wasome design well done.
How do you manage moisture which ALWAYS condensate from smoke in the upper chamber portion and falling down is soaking the chips thus at some point the smoker stops working?
Brilliant idea.. Have you tried to run it with the pipes on the bottom (upside down compared to this orientation)? It's the main difference between Bella Smokin It and the Big Daddy smoker. A CZcamsr showed the Bella Smokin it to be more precise.
Also, can you provide a part list for ease of replication?
Great! I just need to pass idea of plasma cutter to my wife :)
Have you done a temperature check with the cold smoker generator inside a closed smoker? If so, did the temperature inside increase, as the air flow from the smoke generator increased and vice versa? If would seem the greater the air flow, the more chips that would burn greater and faster; creating additional smoke as well as heat. I know I have better luck cold smoking if can keep the temperature below 85 degrees. A great design idea for cold smoking.
very nice...:-}
That's a great design Mike! Is it possible that you can sell or share the drawings of your design so I can make one for myself?
Did you figure it out?
This design is way better than the smoke daddy. I have a smoke daddy and the coiled wire in the middle is a poor design. This design it is impossible to clog up.
you ever come up with a price? Thanks Tom
Thank you very much!!!!
Just I don't get the smoke out. Works for a few minutes and than ? Finished, nothing happening again. I check it out x times x and I don't know what I'm doing wrong. Any idea about?
Help very appreciate 🙏
Nice!
did you ever come up woth a price with shipping.
What is the length of the 16ga 2X2
Mike G, Did you come up with a price on this bad boy? Rob
Short term they all work well, but longterm there are not many results to be seen.
What would change?
the price and shipping cost pls.
Prices?
i will build one today out of a can
where is it good for?
Smoking food.
cold smoke???
оригинально!