According to VCDS program sequence to access the bleeding function is in group one. It is not accessible in group one for an Audi B8.5, it’s in group 10
One question. Some people say, that in Audi instruction you don't need VCDS and it says that you can bleed the abs module by only maintaining the pressure around 2 bar? Is this right?
I confirm this is the case in A6 C6 (Bosch ESP 8 pump). Also the order to bleed the brakes is inverse to the logic (and universally established) way, and you start from the closest wheel to the pump to the furthest. First I tried to bleed the brakes using only VCDS but it didn't work because not all air came out. So I got a pump, put it to 2bar as recommended and brakes were working again half an hour later.
Do you result this problem ?
Can I do this also for rear brakes? I see only front wheels
Yes, the sequence that runs is for all 4 corners. It's simply running the same program repeatedly
Hi how can i get this program to bleed it? Cause I try it with snap on ultra solus and it says not comunication. Thank you
Run diagnostics to see if you have any error codes. I had an error code in the steering which blocked me from bleeding it forst time around
One question. Some people say, that in Audi instruction you don't need VCDS and it says that you can bleed the abs module by only maintaining the pressure around 2 bar? Is this right?
I don't believe so.
I confirm this is the case in A6 C6 (Bosch ESP 8 pump). Also the order to bleed the brakes is inverse to the logic (and universally established) way, and you start from the closest wheel to the pump to the furthest. First I tried to bleed the brakes using only VCDS but it didn't work because not all air came out. So I got a pump, put it to 2bar as recommended and brakes were working again half an hour later.
So you're supposed to open both front left and front right bleeding nipples and then run this?
No, you open one ata time and re run the procedure for all four