HOW To Use The AOD Transmission Harness w/ a T5 Transmission Fox Body Project Car

Sdílet
Vložit
  • čas přidán 12. 09. 2024

Komentáře • 9

  • @TallStarlite
    @TallStarlite Před 6 lety +4

    I just did an aod to T5 swap on my 1990 Mustang following a guide from LMR I didn't have to convert any harnesses or anything and everything works go figure? there's a video series right here on CZcams from LMR that shows you all the steps needed. Basically all the connectors are already in the car with jumpers and are near the clutch pedal assembly. All's I did was unplug the jumpers and reconnect to the new clutch pedal assembly and miraculously it all works for me.

    • @josecastellanos4538
      @josecastellanos4538 Před 5 lety +2

      TallStarlite . Idid the swap using lmr video as a guide but the car did not work as i wanted to. 1st the iddle is bad and secondly the car doesnt rev pass the 4k rpm.

  • @the2ndamendmentwasntasugge463

    Man great video very useful information

  • @turboman351w3
    @turboman351w3 Před 5 lety +1

    i just used a jumper wire

  • @scottatwater5763
    @scottatwater5763 Před 2 lety +1

    I’m doing a 4 cylinder auto to v8/t5. Is any of the 4 cylinder harness useful? Also it appears no one makes the complete t5 harness anymore that you are talking about. They have them minus the plug you are adding. Do you have the part number for that plug? Thanks

  • @Cody_Lemon
    @Cody_Lemon Před 6 lety +1

    My car has a rebuilt 306 with cast aluminum pistons, is that something to worry about when adding boost?

    • @Neomustangs
      @Neomustangs  Před 6 lety +1

      cml3710 just keep it moderate. 10-11 lbs

    • @Cody_Lemon
      @Cody_Lemon Před 6 lety +1

      Neomustangs thanks for the reply, thats with pump gas?

    • @Cody_Lemon
      @Cody_Lemon Před 5 lety +1

      Neomustangs even with 91/93 octane?