Installing a VOSwitch on a Jeep JL
Vložit
- čas přidán 12. 09. 2024
- In this episode I guide you thru the steps to install a VOSwitch, and mount the controls on the driver side grab handle on a 2019 Jeep JL
Don’t forget to Like, Subscribe, Share, and click the Bell
CZcams - / @defiantjeep
Facebook - / 5968967866488923
Twitter - defiantjeep
Instagram - / defiantjeep
Rumble - rumble.com/c/c...
Don’t forget to join us at Desert Wranglers
Web site - www.desertwranglers.club
Facebook - / 466985260038051
Meetup - www.meetup.com...
Literally the only video that shows how to pull the grab handle off on CZcams. Thanks.
Thanks for your kind replay and thank you for supporting Defiant Jeep. Have a great day.
Also Remmer too put bolts back in the grab handle mount
Thanks. What a thorough interior wiring video. Been thinking of grabbing myself a VOSwitch for a while.
Great vid guys thanks. 2 things will improve your project 1 a screw gun 😂. 2. Wash your Jeep 👍🏼
LOL
Just FYI in a manual transmission JL you will have to run the wires thru the windshield like the instructions state. That grommet in the engine bay already has wire ran thru it for the clutch pedal
Great intel. Good to know. Thanks for your input. Have a great day.
how?
@@dr.demaurosoffice1636 it’s in the instructions. Basically, you fold down the windshield just enough to guide the wires into the cab of the jeep
But you didn't cover the trigger wire install.
You do realize there is a wire channel right under where you zip-tied the wire, right?
LOL, no I did not realize that detail. Thank you for pointing that out. When we have to re-route the cable I will make sure to use it. Thanks again.