When it’s regening. You should put numbers along side. For example doc I have some that reach 650 degrees and some that only reach 500 degrees. So put what the optimal temperature should be.
So we are just going to overlook the inactive root cause of the quality code?? Here is my question….what happens after 10 hours of drive time after this? 3712 states the ECM has detected a emissions code that has been unattended for longer than 10 hours.
Same mine keep coming back driver drove without def and it was already crystalized in the pipe where it’s sprayed so it was already not getting in there properly I’m using a Snap-on pro link edge
When it’s regening. You should put numbers along side. For example doc I have some that reach 650 degrees and some that only reach 500 degrees. So put what the optimal temperature should be.
So we are just going to overlook the inactive root cause of the quality code?? Here is my question….what happens after 10 hours of drive time after this? 3712 states the ECM has detected a emissions code that has been unattended for longer than 10 hours.
Sir gd day, this laptop can use for qsk,qst and qxi cummins genset for trouble shooting. Thanks
Thank you, same for isc?
Yes, procedure is the same for all Cummins engines. Good luck!
Mine will not clear a 2016 freightliner I'm working on. No matter how many times
Same mine keep coming back driver drove without def and it was already crystalized in the pipe where it’s sprayed so it was already not getting in there properly I’m using a Snap-on pro link edge