Hydrant Hookup Changeover Training

This video is intended to familiarize driver/operators with transitioning from an apparatus onboard water tank discharging 185 GPM to a pressurized water source prior to running out of water on the attack line. #MDFR #MDFRTraining

[@davidrawlings6116]

Thanks for demonstrating that the fire truck doesn't need to pull up right on top of the fire hydrant, as some code officials seem to believe.

[@SocialistDistancing]

I need a checklist.

[@Darkdeath5287]

Just seems like too much for a water supply, hydrant to pump that’s it, all of that seems like it takes valuable time from the point of the water supply in the first place. And it’s also too many steps to try and remember

[@LJT7907]

Especially the part about putting the truck in gear and leaving it in gear and then it registers as speed on this speedometer ? What the hell

[@DJDeFiore]

When you change from road to pump the transmission changes gear to only power the pump. Since it is disengaged from powering the wheels, the truck wont move. It shows speed on the speedometer since the drive shaft is still moving to power the pump.@@LJT7907

[@jedeckert8912]

Pretty good video but a lot of unnecessary crap on there. Just hook the 5" from the hydrant to the intake valve and be done with it! In particular, the hydrassist valve is not needed with such a short amount of hose.

[@sammitchell7310]

This is far too much for one person to handle 😅

[@JaySmith-or3us]

Few minutes of hell

[@joshroten3997]

Made a simple evolution of the Engineer hand-laying a supply line to the hydrant way too complicated, with too much hardware involved. Good evolution to begin pumping from tank, then switching over to a hydrant before losing tank water, but this example is too many unnecessary steps.

[@TheAubergineMan]

Challenge: Take a shot every time they say hydrant.
P.S. I won't pay for the hospital bills