Creality K1 Max 70mm bridge

I forgot to use supports but it printed very well... stock settings.

[@mokiedee]

Witchcraft!!! 😆 I'll give it a go

[@josephiscooll3]

Did you enable a setting to accomplish this? Also can this be possible at higher speeds? If not, what would be the limit?

[@Doom_Slayer_Arg]

Stock settings, I was printing at 300mm, but in overhangs I think it slows 50%. I forgot to enable supports but realized it was printing pretty well so I recorded it. For smaller overhangs I think you can use more speed.