Thanks for the video. Did that but my watch is now stuck in rebooting mode. No idea what went wrong, the soldering seems pretty good, everything aligned and not touching.
And use a magnifier lens to check that the power cable connector is well aligned with the contacts of the watch board. Otherwise it will not work. And be careful when bending and fixing the two buttons (back & power) on the case so they are not damaged when you put the board back to the case. Its very sensitive and small. And thanks for this video!
This video is really helpful, I'm in the middle of the soldering process right now. My only question here is then to make it get sticked into the motherboard we can put the soldering iron machine literally over the flex cable if i'm not mistaking. Is there any risk of touching the flex cable just over the area you want to solder as you did in the video with the soldering iron machine?
Saved my watch! Requires some tooling and skills, but totally worth it. Thumbs up for you 👍
Thanks for the video. Did that but my watch is now stuck in rebooting mode. No idea what went wrong, the soldering seems pretty good, everything aligned and not touching.
Best vid for this procedure I've seen on youtube!
And use a magnifier lens to check that the power cable connector is well aligned with the contacts of the watch board. Otherwise it will not work. And be careful when bending and fixing the two buttons (back & power) on the case so they are not damaged when you put the board back to the case. Its very sensitive and small. And thanks for this video!
My watch shows that's it's charging on the charger, but it won't turn on. What can be the problem? Please assist me
question? what temp do you solder? seems to me that cable tip would melt. Great Video!
This video is really helpful, I'm in the middle of the soldering process right now. My only question here is then to make it get sticked into the motherboard we can put the soldering iron machine literally over the flex cable if i'm not mistaking. Is there any risk of touching the flex cable just over the area you want to solder as you did in the video with the soldering iron machine?
Nice video! What's the name of the fluid you added before and after soldering?
it should be alcohol
sorry for the late response. thank you so much for liking my video. the name for the fluid is noncorrosive soldering flux
Hola tengo el mismo problema, donde puede comprar ese mismo repuesto y como lo solicito?
ese lo compre por medio de amazon. solo me costo como $10 dollares
Como se llama el repuesto?
It need screwdriver Y 0.6mm size? Why you don't try repair the flat cable before changing?
the cable was damaged i tried to resoldered it but did not work
@@letsfixittogether1402 size of power botton? Have you try also to change only buttons before the flat cable?
Where you buyed the flat cable?
Samsung service centre is telling me that I need to replace both display and button strip it cannot be done seperately
HELLO