Making of long shaft (turning)manual lathe

Making of long shaft (turning)manual lathe
Production of a new long shaft for an agricultural machine
Machines:
Lathe SUI 50
Horizontal boring and milling machine SANCO SM-FB100NC
Production: ruckbs.sk/
My video editor:
www.mvvitrk.co...
металлообработка дневник сельского токаря слава петров ремонт вала рукоятки
#cncmilling #cnc #cncfrezar

[@CncFrezar]

Hi friends. Now we do not have a publishable work on a cnc machine, so I will introduce you to work on a lathe as well. I hope you will like it. I have good colleagues.

[@TheDayzman]

Lathe work is cool and stuff, but can you show more horizontal mill work? There isn't much out there on yt in comparison to lathe work...
I guess I like pretty much everything you guys do but seeing more horizontal mill work is the thing that I am most looking forward to.
Have a great day and thanks for making these videos.

[@CncFrezar]

@@TheDayzman Yes. If my colleague does some interesting work, I'll try to film it. I have to figure out the location of the camera and then it will be ok.

[@TheDayzman]

@@CncFrezar Thank you

[@mirohornik98]

Super video!!!

[@cnccrusher1652]

Nice!

[@DolezalPetr]

ta odlitá hliníková palička je teda super

[@madaxe79]

I have the same lathe... haha

[@CNCAkademy]

Nice

[@mitchelle05]

What do call that attachment you use for setting up the other side of the shaft connected to live center, like a magnetic one

[@dontfeelcold]

It sounds like there is a night club next door with the music I could hear.

[@CncFrezar]

If you were right ... :-)

[@tewodroskassayeaboset1607]

Hello I have seen your vedio it's very interesting and you followed right procedure while you are working in the machine. What I want to ask you that if there is any possibility to get used lathe machine and some other accessories from your end. If so, please help me to fine this things.

[@NotInService]

Now for future videos on how to make a part, I think it is important to show how you set the job up not just show us how you make chips. After all, if the setup is good chances the job runs great but if you don't set up properly well we know what will happen.

[@babylyncorpuz5351]

WHAT IS THE SPEED WHEN YOU TURNING LONG SHAFTING

[@chrismason598]

Around 600rpm if you are using a carbide insert in carbon steel with .020 ipr feed rate

[@magnum357225]

Hi can you please tell me what quality steel did u use
Thanks

[@user-jg5nd8fs9y]

Подачку то добавь, не будет виться...

[@Sketch1994]

TOS Suil?

[@CncFrezar]

Tos Trenčín

[@matejstrapko905]

Susrtuh sv45r?

[@CncFrezar]

Ahoj.SUI 50 je to v popise pod videom

[@andrejhudec7134]

ej ale to pasovalo

[@user-jg5nd8fs9y]

Противная стружка!