Full diagnose for dead laptop motherboard plus steps of manual CPU reballing without stencil
Vložit
- čas přidán 25. 07. 2024
- Step by step laptop repair and troubleshooting a HP dead laptop, full diagnostic started by checking the charger, CPU cooling temperature control, Bios CMOS reset, motherboard main power supply and regulators, RAM memory card, CPU chip reflow and reheating, CPU chip reballing, new CPU chip installation.
- Věda a technologie
thank you so much, I value your works and you are a good repairing man, you followed logical steps until the end, and I was happy to learn from you, even I am an electronics doctor and I am a professional repairing man, Thanks a lot
Thanks very much for your great feedback, and in fact this is a wonderful words I will be proud of to value what I am doing from a professional.
Thank you for sharing this knowledge, Mr. Saud. This manual reballing requires a lot of patience and skill.
You are very welcome, and thanks for you as well for feedback,
indeed you are right alot of patience is required, but the interesting thing as you continue practicing this it becomes enjoyable.
Selamun Aleykum and thank you for sharing this mr. Saud. You've made me smile at the end with the song. May Allah also make you smile. Best regards.
Many many thanks to you for good prayer.
Amin 🙏
Fantastic video!!!!!
love you
very good
Thanks 👍
Thank you Saud. I will like to know if it is solder paste you are using for sticking the CPU to the board
Hi, you are welcome,
In fact we need to use good quality solder flux ( can be gel or lequid) for that step this will insure good solder join between the CPU BGA and board pads during reflwo,
Yes some they call this solder Paste but solder Paste is defferent that's a gray color thick flux can be used for anther way of BGA reballing plus other use.
Thank you sir for sharing this one, I really enjoyed it I learned somethingto day. you cracked me up smiling at the end with the song. true, not all repairs come to fruition. repair is all about setting boundaries or limit to what can be repaired, though a chalange might sometimes to be of fun from time to time. may allah bless you with health and knowledge
manually reballing the processor is like counting the stars and remembering it the next night to start again
lndeed you have described it right.
Jeez your patience levels must be sky high to manually put each new solder ball onto the chip like that.
Thank you very much for your comments and your real feelings. Indeed, this requires a lot of patience and time, but the good news is that with repeated practice of doing this manually, it becomes more and more fun.
ممكن رقم تواصل
saudautomation@gmail.com