PFT G4 plastering station cleaning | Exploitation

Colleagues, cleaning the plaster station is a very important point and a guarantee of trouble-free work:
When do I need to clean the plaster station?
Be sure to !!! Clean the machine after the shift
It will take no more than 15 minutes and will save time in the future.
How to clean the mortar hose and the snail?
Disable plastering
Remove the mixing helix and clean the mixing helix from the plaster.
How to clear from mixing the mixture mixing zone?
Insert the shaft of the cleaner, make sure that there is water in the mixing bin and start the cleaning process, after the appearance of a characteristic noise, check if the cleaning has ended and replace the shaft of the cleaner with an already cleaned cochlea.
Clean the 2 water pipes with a shtichling.
Using a brush (non-metallic), rinse the mixing bin, after pre-adding water there
And how to clean the mortar hose, because it is very important?
Disconnect mortar gun
Rinse the hose with a ball 2 times
Clean the inner and outer parts of the hose and plastering machine connections with a shtihling.
Rinse the hose with a ball 1 time.
ATTENTION: at all starts of the engine, make sure that there is water in the bunker!
How to clean the mortar gun?
Disassemble the gun completely
Clean the metal air tube especially inside.
Clean the rubber nozzle
Clean all inside holes of the gun
Clean the mortar gun outside
Assemble gun
------ All operations are carried out with the help of shtihlinga ---
I am for the high culture of labor, that you need to clean more?
Remove all dry (dusty) mixture from the plastering machine and its components
Remove dried plaster
Wipe hoses
Filters need to be cleaned? How often?
Remove and clean 2 water filters (if the pollution of the filters is minimal, the cleaning procedure can not be done every day)
Check the air filters, but they should usually be cleaned no more than once a week.
When all the work is completed at the facility, what else should be cleaned?
To clean the feed bin from the plaster mix, wipe, clean with a brush (not metal)
Wash all hoses outside and fold them carefully.
Wipe the wires, after making sure that they are disconnected from the electricity.
Clean the plastering machine and all its blocks more thoroughly.
Assemble all the components.
Our information site: pft-master.ru
Our instagram: / pft_master
Our page vkontakte: pftrus
Our facebook page: / pftmaster
For more information, contact PFT-MASTER, our managers will select the equipment for your needs. Also here you can visit a master class on the topic: "Mechanized plaster" and "Mechanized putty".
Contact the manager by phone [phone] (calls within Russia are free) Call during business hours from 09.30 to 17.00 (Moscow time)

[@plaster5672]

Требуется ли разбирать и промывать шнековую пару после чистки нижнего фланца, если на следующий день новая рабочая смена на том же объекте?

[@PFT-masterRu]

Здравствуйте. Её нет необходимости снимать пока она не выработала свой ресурс.

[@ilhomahmad92]

Во внутри шланг есть салник необходимо его убрать! Потому что могут потерять и это тоже займет хороший пока его найдете или другой покупать придется !!!!

[@rolos71]

una consulta podría usted hacer una explicación en español,gracias

[@vyacheslavsensor1607]

только чистка станции занимает не 15 минут а раза в два три больше рабочего времени