The D model uses the same chip. I know this because I had the main IC fail when someone tried to measure a car battery with the leads setup for milliamps. I was looking at the VC99 for a possible donner IC. Found a new IC on Ali-Express that worked out perfectly and after re-cal vs my 3457A all has been well. I now use that meter as a kick around for being brought back from the dead. I've found it to be a good enough meter.
which of these do you actually prefer? I notice you are using the Vichy 99 in your later videos... does this mean you are leaning towards that one? or whats your thoughts on Vichy vs Uni-T ?
does the voltage sometimes over shoot? lets say that you have a power supply that is set to 20 volts when you use your leads does it jump higher than 20 volts lets say like 30 or 40? Thanks
Disculpa la molestia quisiera saber si una vez conectaste el tester a una pc. Si podrías darme una mano por que no me da la lectura en tres computadoras diferentes. Te dejo el link, saludos. www.yoreparo.com/es/computadoras/preguntas/6270310/necesito-solucion-el-software-del-unit-ut61c-no-funciona
The D model uses the same chip. I know this because I had the main IC fail when someone tried to measure a car battery with the leads setup for milliamps. I was looking at the VC99 for a possible donner IC. Found a new IC on Ali-Express that worked out perfectly and after re-cal vs my 3457A all has been well. I now use that meter as a kick around for being brought back from the dead. I've found it to be a good enough meter.
Is there same RS-232C interface (protocols) in UT61C and UT60A?
please test also the transistor
which of these do you actually prefer? I notice you are using the Vichy 99 in your later videos... does this mean you are leaning towards that one? or whats your thoughts on Vichy vs Uni-T ?
uni-t 61e probably has the better value for money...
Hi please how to measure the capacitor of transistor with this multimeter
Unfortunately transistors cannot be measured by this unit.
does the voltage sometimes over shoot? lets say that you have a power supply that is set to 20 volts when you use your leads does it jump higher than 20 volts lets say like 30 or 40?
Thanks
Lex luthern no bro
is it normal that the numbers jump like this ??
and why it beeps on the second range as I change
hay pleas diagramme
Disculpa la molestia quisiera saber si una vez conectaste el tester a una pc. Si podrías darme una mano por que no me da la lectura en tres computadoras diferentes. Te dejo el link, saludos.
www.yoreparo.com/es/computadoras/preguntas/6270310/necesito-solucion-el-software-del-unit-ut61c-no-funciona
In English, this guy is asking if you could show this hooked up to a computer.
The website link says that it doesn't work.
FLUKE ♥
Whath up withh that lispth?