Hello excellent video. I have a NFS-320 Panel, I install and connect Bacnet GW-3 (Bacnet GW-3 card is connected with a nub cable directly to Panel), when I discover or update the node list, the Panel does not appear in the interface of the gateway, do I have to do any steps in the Panel? Do I have to enable any special parameter within the panel?
Dear we have GENT BY Honeywell system Commissioning files transferred to the BACnet card and FA panelsdetailed data has been monitored by BMS.However, our concern now is to send only a common firesignal and double nock signal and fault for each node Could we brief and sent information to BMS to be only thesesignals? Thanks
Hello sir. How to connect between: 1 Nfs640 1 Modbus Gw 1 NCM. Because If I use Facp Nup to Modbus GW, I can’t find setting for DNS. only Ip, subnet and gateway. I need to setup DNs for connect to Internet Please advice. Thanks
-Using a USB Drive Create a the file “default.ldc” -connect the USB Drive to the gateway and Reconnect the power -(USB maximum up to 4GB) -wait for about 3 min
Hello excellent video. I have a NFS-320 Panel, I install and connect Bacnet GW-3 (Bacnet GW-3 card is connected with a nub cable directly to Panel), when I discover or update the node list, the Panel does not appear in the interface of the gateway, do I have to do any steps in the Panel?
Do I have to enable any special parameter within the panel?
hi sir, do you have a BACnet GW-3Configuration Tool software?
How to get configuration software? if you have link please share to me
hi can you help me to find out value of resistor in this card R239 , R240
Dear we have GENT BY Honeywell system Commissioning files transferred to the BACnet card and FA panelsdetailed data has been monitored by BMS.However, our concern now is to send only a common firesignal and double nock signal and fault for each node Could we brief and sent information to BMS to be only thesesignals? Thanks
Hii
Sir I have a problem in the system that my client computer auto shuts down, due to this all my nodes also shut down, you can help me.
Hello sir. How to connect between:
1 Nfs640
1 Modbus Gw
1 NCM.
Because If I use Facp Nup to Modbus GW, I can’t find setting for DNS.
only Ip, subnet and gateway.
I need to setup DNs for connect to Internet
Please advice. Thanks
Configure the network at the light control cabinet by turning the node to node 1 and bacnet's IP 192.168.1.2. You can check the IP by pinging the IP.
@@wichit1982 Actualy I used Modbus GW not Bacnet.
There's no DNS setting insisde Modbus GW.
but, on Bacnet GW, can you setup for IP and DNS?
Hello sir,
How to factory reset BACnet GW-3 card
-Using a USB Drive
Create a the file “default.ldc”
-connect the USB Drive to the gateway and Reconnect the power
-(USB maximum up to 4GB)
-wait for about 3 min
@@wichit1982 How to create "default.ldc" file
@@akgk8028 txt file name
default.ldc
@@wichit1982 Bacnet gateway card reset done.
@@akgk8028 did you by chance did a video with the process?