How to Repair your MINICROSS / MINIBIKE !
Vložit
- čas přidán 27. 08. 2020
- How to Repair your MIMINICROSS / MINIBIKE / PIT BIKE !?
This video was created because my son's minicross/minibike started to start terribly hard, sometimes it didn't start at all and other times during the ride the engine stopped for no reason.
So that's why I decided to make a video and maybe it will help the parents of small bikers who have a similar problem with the minibike/minicross. - Auta a dopravní prostředky
You tuned that bike wonderfully. Throttle response was nice!
Fajny patent z tym wbijaniem simeringów zaworem!
Very helpful video, thank you!
Muito boa essa modificação na parte do acelerado um gênio
I watched lots of the videos about 2 strok minibike, the sound of yours is best！！！
Genial. Tanks for yu experience saludos desde Mexico
In one word : Cool.
Like the fuel tap mod Good work
Very nice video. Thanks
Good one
Big Christmas Cookbook 👍❤😁
real nice man
5555555
Good job.
ciao, where did you get the spare parts? thanks Simone
really good video did you ever narrow it down to the cause of why it was so difficult to start and stay running my son's bike does pretty much same thing it's a little moto bike with the same motor as you got but I can get it to start and he can ride it for like 30 seconds and it bogs down and eventually quits and then won't start back for a little bit. Any advice would be appreciated thanks
Sounds like carb problem check the bottom where float is and the jet in there. I had a similar problem and found dirt in there cleaned it out now runs awesome
heii jawa, i like your video .. are you from indonesia?
I come from Czechoslovakia.
@@jawatino3797 theres a lot of really good looking women from that neck o the woods
34:46 12 year old susuki riders at the gate
Excelent educational shooting. Did you find out what was the main reason for the bad starting? I am rebuilding the same kind engine, which has been stopped for several years.
takze jste z cr :D
Mean my bro
What code size for oil seal?
💖💖💖🏍🏍🏍🏍🏍👍🔔
2:50 i wanted to remove the clutch but it was to tight and i used to mutch forse so there broke a carter piece
Amigo que hago cuando una moto de estás no me quiere prender manual
Náhodou tenhle motor ale popisky v češtině by nebyly? Nemám jak to překládat
no need engine oil ????
Dude is 2 stroke is not 4 stroke
I put new engine on still won't start new carburetor new spark plugs still won't start x pro 50cc dirt bike hawk
Did you check for spark? Is coil pack line up correctly
@@MoBLuBSiAb4LiFe yes everything new
Try the fule valve mod he did on the carburetor. If it has the 4 way rubber gasket on the inside it is just a very bad design and creates a vacuum lock where fule can not flow .
I can confirm about the fuel line valve. My kid had a similar problem. The bike would run for about a minute and then stop (right before stopping, it would rev by itself for a second). I found that the screws holding the front plate of the valve were too tight and fuel flow was bad. The bike would empty the carburetor faster than the fuel could come in, and that is why it was reving before it shut down - there was more air than fuel in the carb. Unscrewed the bolts for 1/4 turn and the bike worked normally ever since.
I turned the valve off and cleaned the carb for the winter and when turned the valve on again yesterday. It started leaking fuel as hell. It stopped once the rubber got greased by 2 stroke oil. This valve is a nightmare. I think I will also do the same mod like Tino...
Also, guys, what mix ratio do you use on those bikes? By the book it should be 4%, but there is so much smoke and oil residue in the exhaust that the bike will stall in a minute or so if left idling. What oil and what mix ratio do you guys use?
Kid was raised right