@@ndf-modellbauvideos Hey Frank, just checking, your CG are following with the factory setup? which are 135mm from leading edge? I have question is because I've bought the same ESM Val but in version 2 format. the challenge is that this plane came without manual and I have to think out from the box most of the time to assemble this plane... Forum did not help mush as this plane are not widely available, thus approaching to fellow flyers in CZcams for guidance..
@@AndyYuenRC Hy Andy Yes,i take the original CG 135mm from leading edge. It is an safety point. The Modell neet large flap deflections. (see the short video) Always leave the throttle on when landing, otherwise the model will abruptly nose down. The landing is very similar to that of a GeeBee R2! This means: keep the model upright and work with the gas position. The Weight is 7950g dry! I hope I helped you and if you have any questions.....at any time!
How much weight have you added to get the CG right for this plane and what engine are you using?
Hy
770g near the Firewall and i have an CG20 Engine with 16x8 Graupner Nylon Prop
🍻 Frank
@@ndf-modellbauvideos Thanks for responding :)
Gladly!
My keyboard's autocomplete was playing tricks on me
..🥴the engine is called ZG 20 (Zenoah) and not CG 20!
Excuse me!
🍻 Frank
@@ndf-modellbauvideos Hey Frank, just checking, your CG are following with the factory setup? which are 135mm from leading edge?
I have question is because I've bought the same ESM Val but in version 2 format. the challenge is that this plane came without manual and I have to think out from the box most of the time to assemble this plane...
Forum did not help mush as this plane are not widely available, thus approaching to fellow flyers in CZcams for guidance..
@@AndyYuenRC
Hy Andy
Yes,i take the original CG 135mm from leading edge. It is an safety point. The Modell neet large flap deflections. (see the short video)
Always leave the throttle on when landing, otherwise the model will abruptly nose down. The landing is very similar to that of a GeeBee R2! This means: keep the model upright and work with the gas position.
The Weight is 7950g dry!
I hope I helped you and if you have any questions.....at any time!