Part 10 Freightliner Sprinter 3.0L OM642 Intake Manifold Swirl Runner Connecting Rod Replacement

Part 10 Freightliner Sprinter 3.0L OM642 Intake Manifold Swirl Runner Connecting Rod Replacement
A common failure inherent to the intake manifold of Mercedes-Benz OM642 V6 CDI / CRD engines is for breakage of the actuating mechanisms on the intake swirl flap system. The plastic material used in the construction of the intake manifold is the main source of the problem. These swirl flaps help create better torque low down and enhance fuel economy. However the material of this lever that controls the swirl flaps has been incorrectly specified. Over time this less robust plastic material cannot withstand the constant heat cycles and mechanical stresses, therefore embittering and weakening the material leading to inevitable failure. Our Premium intake manifold repair kit is the only solution which solves all of these issues during your first and only repair...
One of the faults of the OM642 diesel engine is the defective intake manifold flaps, they stop working due to the wear of the chuck fixing clips, the thrust guide of the connection to the flaps, and the seat plates on the dampers levers.
The cause of wear is the material from which the vortex dampers drive system itself is made - plastic.
Over time, the connection points of the linkage and the flaps wear out, this leads to a malfunctioning system of the vortex dampers of the manifold of the Mercedes.
Engine control module stored pending codes for Intake Manifold Air Flap or Runner Control System problems, in order to fix this problem need a complete replacement of the "Intake Manifold Assembly".... but by using our new repair kit, specially designed to save you money, you will not have to replace complete Intake Manifold Assembly.
Repair Kit Includes:
================
- 2 X Aluminum Rods (for Right or Left Intake manifolds)
- 6 X Anti-friction adapters (contribute to easy slip. protect from wear and tear).
- 6 X STRONG New Retainer Clips (fiber glass + plastic)
- 2 X Link Rod Ball Socket - Genuine Mercedes

[@remigijusosinskis3968]

Cat are checking quality of assembly 😁

[@T1G3RKN33]

What are those sensors for? I don't have them on my engine.

[@ThatLapisGuy]

Where can I buy this repair kit? Your website doesn't seem to be working

[@rson7421]

You can buy this repair kit from Desertcart

[@gabakusa]

can you just leave those little valves open always? and get rid of all that mechanism?

[@fedecarughi8370]

Yes, actually is the way to fix it and don't have problem never more

[@49mus]

Very nice Job 👍👍👍

[@jmdonasc]

Do you have video on cleaning these manifolds?

[@ZimaletaMotors]

Yep here’s one using parts washer Parts Washer from Harbor tools and freight
czcams.com/video/jqhU_ZDROz8/video.html

[@ZimaletaMotors]

Here’s one using DIY hot tank My DIY Hot tank setup for cleaning parts
czcams.com/video/WhQJQWz3w6g/video.html

[@MsRotund]

How much a job like that it’s going to cost me I have the same problem with the runners they get stuck

[@Slim3rC10]

Try the resistor trick see if that solves any limp mode issues.

[@karldingbat]

People who dont know what they are doing should not put up videos showing others how not to do something!

[@gitrdonedumpsterrentals1023]

Duuuude, I was like Why The Hell he trying to teach us when even WE see he has the rails on backwards. 😢

[@karldingbat]

It's like watching a comedy show, please stop untill you know what you are doing 👎