Is it possible to drill out the metal drives haft hole up a size to make it fit the output shaft of the trans? Also does it look like the trans mount could be cut or removed to fit a wpl big motor and 2 speed?
I think it is possible to widen the hole of the drive shaft, but at present I am thinking of covering the shaft on the axle side with a sleeve so that a standard shaft can be used. I think the WPL gearbox can be replaced, but I do not recommend it because it has a ledge down and has the same ground clearance as other MN models.
Very nice upgrade my friend. Looks awesome.
I have already an mn99 and putting portal axles would make too high so mn78 would be the perfect one to put portals.
Very nice👍🤩
Is it possible to drill out the metal drives haft hole up a size to make it fit the output shaft of the trans? Also does it look like the trans mount could be cut or removed to fit a wpl big motor and 2 speed?
I think it is possible to widen the hole of the drive shaft, but at present I am thinking of covering the shaft on the axle side with a sleeve so that a standard shaft can be used. I think the WPL gearbox can be replaced, but I do not recommend it because it has a ledge down and has the same ground clearance as other MN models.
Bagus sekali rc nya
Can you auto generate English subtitles?
Hello.
I'll try and see, but it may take some time.
F.y.i. you can use the 4mm bevel gears from the 78 in the mn portals and maintain the nicer 4mm drivdshafts
Mas barang bekas nya mau jual ngak
I'm sorry, but I didn't buy it.
shock pakai apa sir
Shocknya menggunakan stock spring yang sudah dimodifikasi.