Never run the the threaded end of your two hole bolts from the back side of the flange. Thats a bad habit that you will eventually regret big time, because you will tack the flange on in a tight area and wont be able to get the two hole bolts out. Always run the threaded end, in from the flange face side.
Alot of people hate doing socket welds and working with spaghetti but i love it and love threading too!
Nice!
A lot*
nice work on that,also to mention that when setting fitting be on point because carbon doesn't like to move much after first pass . nice work sir .
Thanks for the info!
Where did you buy the elbows. I can't find the style with the flat edge on the side
Thanks Nate
You're welcome
Good tips and tricks
Glad you think so!
At least a 1/16th gap between the pipe end and where it bottoms out in the socket right? It was kind of hard to see is the video@
Never run the the threaded end of your two hole bolts from the back side of the flange. Thats a bad habit that you will eventually regret big time, because you will tack the flange on in a tight area and wont be able to get the two hole bolts out. Always run the threaded end, in from the flange face side.
thanks for the advice