Parkside 3 in 1 Gas Soldering Iron Set PT370 Review from Lidl UK
Vložit
- čas přidán 29. 08. 2024
- In this video Andy reviews the Parkside PT370 gas soldering iron / hot air gun / blowtorch, which is currently available at the Lidl supermarket chain in the UK.
- Jak na to + styl
I have this same one, read the manual!! The plastic cover is a heat protector NOT TO BE USED WHEN DEVICE IS ON!!
It’s to prevent a burn injury!!
There is flame adjustment, it is a red slider. Also for refueling no adapter is required, but you need to put a rubber gasket on the filler, so it doesn't leak. You can get one from any cigarette lighter. Otherwise it works well.
I found the flame adjustment now. It doesn't seem to make much difference though. It does change it a bit, but not as much as I would have expected. I'll try the trick with the rubber O-ring.
I was going to comment this too but I noticed towards end you found it!
@@AndysShed HEY THERE I USE THIS ONE TOO I CAN SAY THE CAPACITY IF THE INNER GAS TANK IS SO LITTLE . WHAT PIPE DO I NEED TO SCREW IN TO FEED IT WITH GAS FROM A SEPARATE CANISTER ??? THANK YOU
Thanks for the tip sir.
I found it works ok! Issue I had is the pointy tip didn’t work great and after a few uses the flat tip has broken!
Tips break though so for price worth the ability to use anywhere without restriction!
Just be careful of the exhaust hole near the tip! :)
Do not use the green protector when the gas is on. It is to stop burns when the device is off and cooling.
Thank-you.
Perhaps a follow-up using it also would be of interest.
HEY THERE I USE THIS ONE TOO I CAN SAY THE CAPACITY IF THE INNER GAS TANK IS SO LITTLE . WHAT PIPE DO I NEED TO SCREW IN TO FEED IT WITH GAS FROM A SEPARATE CANISTER ??? THANK YOU
Does ist still work?
Yes, still worling in 2022.
@@AndysShed Thanks for the answer. 😊
I answer from Germany. Filling with gas is ok as you did. It says (in the German version) in the description max.1 second! in just one short burst. And it would be full as soon as gas leaks out. My question to everyone is: What is the maximum time someone has soldered with one filling?
Thanks and best regards
That's a very good question. It all depends if you re-light it every time you want to use it or if you keep it lit in one hand. It seems to last a good few minutes. However I use it more as a heat gun for heat shrink sleeves on cables than I do as a soldering iron.