ZWO AsiAir Plus Skywatcher EQM35 Mount,
Vložit
- čas přidán 3. 10. 2022
- Configuring the ZWO can be tricky with the EQ35 mount. Guiding patterns are all over the place many times due to a stiff mount. (Thanks Frank S. for pointing this out on my last video) Attaching a ZWO imaging camera to the William Optics ZenithStar 61 using a Flat 61A field flatter is also tricky. HUGE SHOUTOUT TO MR. ROOFER AND THE #trooptribute. his web address was listed incorrectly in the video it is MrRooferCo.com be sure to check out his channel here: / @mrroofer and the tribute video here: • Mr. Roofer Troop Tribu... . Also check out Kamil Pekala and the EQM 35 Mount mod video found here: • Sky-Watcher EQM-35 - m...
- Věda a technologie
Always thrilled to see another Veteran in this hobby. What a wonderful story on your roof and spirits. May God continue to bless you and inspire more videos.
Really enjoyed the video Bill, keep it up! Clear skies!
Thanks so much.
Merry Xmas Bill. Awesome story with MrRoofer. Amazing they came through for you. I have almost the same setup you do and was wondering if you post a link to the USB cable you used. The USB port on the main box is kinda shallow and I can’t find a cable that plugs in with a lot of confidence. Thanks, and congrats on the new roof. Hopefully, it’s all done by now.
Just bought a Sky Watcher EQM-35i to replace my Sky Watcher AZ GTi mount. Hasn't arrived yet, but think it is like the EQM35. Oh, and just subscribed.
Did you have issues finding objects? Some say it’s off a few degrees because the gears have low quality grease.
how you connecting the mount to the asiair? (as what cable) just a usb cable? or eqmod? as i have an air coming tomorrow for my se eq35
How did you connect the usb cable on the mount directly to the ASIAIR plus?
Hi, can you provide a link for that mount cable? Thanks
I just bought VERY similar setup, EQM35 Pro and ASIAIR Plus. USB 2.0 port on ASIAIR, BUT what port on the mount?
how did you get the asiair plus working with the mount, using USB port only? I have an ASIAIR Pro and wouldn't detect it on EQMOD, even baud 115k
Try updating the ASIAir Firmware. This is the plus. Also not all cables are equal make sure you have a nice cable that is shielded well.
just a short question. Can the EQM-35 carry a 6 inch newton for astro photography? Or is a heavyer mount neccessary?
HEQ5 or EQ6R are needed.
Quick question, with the Asiair there's no need for the sky-watcher wifi module? Or is it's good to have anyways?
It’s always good to have a backup, as long as it’s functioning properly it isn’t needed though.
A HEQ5 mount slewing is only 2A and nowhere near 6A
Why so long backtube? Dont have flattener?
No it is a long long back focus for this scope. 55mm standard and the flattener adjust out for another 16mm.
Is that the normal guiding error for this mount ?
Unfortunately it is common because the mount is too stiff. That will be the next upgrade. Any suggestions?
@@AstroSeabee I use two mounts, the new GTI with my redcat 51 guides about 0.5 to 0.8 and an EQ6R does about the same for the bigger 115EDF