Life saver, couldn't remove bottom panel because I was worried it would break. Only person I found on internet who could offer that information. Keep up the good work. SUBCRIBED 👍
I have a 94 that I just installed my old Pioneer 7000BT into. I wish I would have seen this video first but now I know how to change out that burnt buld and how to take off the upper portion. I was using screw drivers to pry it off but not anymore. Thanks for the simple and quick video. Thumbs up!!! On a side note, it sure would have been nice to be able to remove that storage bin below when I ran my amp rca's and remote wire. Now I know hehe.
Finally I found a video of how this is done on a 93-97 corolla... I just have to change that lightbulb. I bet this video would get a few more views if that was in the title of the DIY-tutorial. " Light bulbe replacement corolla console " or something... but anyways... thanks! Good stuff... maybe i can finally see the fan and heating options for the first time i years when I do this tomorrow. :)
Thanks! Thinking I'll take off the lower console in order to replace the cigarette lighter, which is shorting and blowing the fuse apparently because it's coming apart when used to charge a phone (the spring and another piece started floating around). Taking the parts off will make it far easier to give them a good cleaning & treatment to spruce up the look.
Are there 2 connectors (or just one) on the back of the stereo?,we cant see them in the video. Btw my car a 97 corolla (rhd australian spec) sedan has a white plastic locking tab directly behind the square storage compartment below the stereo panel. 😔😔 I discovered this after several hours of frustration & vulgar language! 🤣🤣 All u need to do to find it is reach around the back of the console & feel for it & then push the tab slightly upwards until the panel that holds the cig lighter socket comes undone 😉
Justin Woosley you need to remove the 3rd brake light, rear seat bottom, and rear seat back. If you have 60/40 folding seats you’ll need to remove the seat bottom, fold the seats down, remove the 2 side bolsters and the plastic trim. After all of that you can remove the rear dash panel to expose the speakers
Hey, Do you know if there's much difference in this process for RHD corollas? I was unable to remove the plastic with the cigarette lighter and ashtray holder - it seems to be locked in somewhere.
Robert Griffith I checked with a friend of mine that has one in Australia and he said the process is the same. Like I said, some are pretty tough to get out
there are all kinds of things that can go there. these are all just some of the things available in other countries though so they would have to be sourced and imported. there's the multibox, air fantasy, secret box, graphic equalizer, and a few other things that can be found. as for things you can use from the usa, you can use the storage compartment and cup holders from an 8th gen corolla that looks really good if done right. you can search the local junkyards for regular single din storage compartments. anything will work from like 1970 to 05 lol. if you'd like more info and some pictures just pm me and we will get in touch
+DIYCorolla No way you can fit a double din when slot fits only din 1. Stop guessing. Above radio has vents. Below radio has air vent selectors. Again, not on a 1997 model for direct fit.
angelisone okay, first off, don't be an ass and use your head for a second. This CAN be done. You mound the double din where that large useless storage bin is above the cup holder. The radio wires reach there because that's actually where an upgraded tape deck mounts from the factory. Then, you go to the dealer and buy the delete plate that goes below the air vents because not all models came with radios. Know your shit before you comment.
THANK YOU!!!!!! You’re the ONLY ONE to show us you actually taking it apart. That’s soooooo important!!! You nailed it!! ❤️
You’re welcome!
Currently pulling apart the dash to run subwoofer wiring to the rear and this saved my life haha, I was in such a jam. Cheers!
ESP LRG no problem 👍🏻
Life saver, couldn't remove bottom panel because I was worried it would break. Only person I found on internet who could offer that information. Keep up the good work. SUBCRIBED 👍
Jose A no problem
Thanks!! You showed us you actually taking it apart. That’s super helpful. Everyone else ain’t do that. ❤️
I have a 94 that I just installed my old Pioneer 7000BT into. I wish I would have seen this video first but now I know how to change out that burnt buld and how to take off the upper portion. I was using screw drivers to pry it off but not anymore. Thanks for the simple and quick video. Thumbs up!!!
On a side note, it sure would have been nice to be able to remove that storage bin below when I ran my amp rca's and remote wire. Now I know hehe.
Thanks, this video show us how to take it apart step by step.
No problem. I’m glad it helped
Finally I found a video of how this is done on a 93-97 corolla... I just have to change that lightbulb. I bet this video would get a few more views if that was in the title of the DIY-tutorial. " Light bulbe replacement corolla console " or something... but anyways... thanks! Good stuff... maybe i can finally see the fan and heating options for the first time i years when I do this tomorrow. :)
I'm glad I was able to help :)
Japanese cars rock Got a buy yourself a Toyota Corolla I have a 98 ☝🏻☝🏻☝🏻☝🏻
i have a few old toyotas. i have a kp61, two ae82 sedans, an aw11, and an fj80
@@Tylerstoyotas Japanese car always Win
This video help me a lot of effort and some money. Thank you very much friend!
You’re welcome
Thanks for the video. My car doesn't have a clock. I just installed one.
sweet!
Hahaa i have clock but thats all i got😂 no powersteering, no seatwarmers, no mirrors at sungaps, only one seat has handle at roof
Thanks! Thinking I'll take off the lower console in order to replace the cigarette lighter, which is shorting and blowing the fuse apparently because it's coming apart when used to charge a phone (the spring and another piece started floating around). Taking the parts off will make it far easier to give them a good cleaning & treatment to spruce up the look.
Thank you. It is really helpful.
You’re welcome
this video Save money.my car is corolla 106 wagon.same center console.Thanks lot
brayan thomas glad to hear this helped you
great tutorial and would like to see more for this make / model!
Great video, very helpful. Just wondering what type of bulb is required for the center console light?
Ah so that’s how it’s done. Got me a 94 hatchback Corolla this week and the manual had no info on how to remove the factory radio.
Thanks! Just what I needed!
Thanks for the tutorial
Thank you I can manage that myself
You can do it!
Very helpful!! Thank you buddy!
Shashika Bandara no problem my friend
super helpful. I need to fix my sliders to direct the air flow. any ideas on that? Right now it all goes to defrost. will not go to floor or face
Sorry for the late response. Your issue is either a broken cable or the piece that holds the cable on either end is broken.
Thanks heaps for that.. made my job easy.
Mark Pettersson you're welcome
Thanks for sharing, I'm going to do it myself.
Ty man👌🏻👌🏻 needed that advice. U know how to get hands on interior light? Planning to swap led in it.. my corolla is 1993.
if you mean the dome light then that can be gotten at the junkyard
Hi...did you install a new radio ?...can you please recommend a stereo receiver able to replaced the old one ?...Thank you.
In the base model, is the writing for the clock already there? Can I just by a clock and pop it in, or will I have to run some wires? Thanks
Wiring is already there. You can reach back there and find the connector taped to the harness
thanks for sharing！
No problem :)
Are there 2 connectors (or just one) on the back of the stereo?,we cant see them in the video.
Btw my car a 97 corolla (rhd australian spec) sedan has a white plastic locking tab directly behind the square storage compartment below the stereo panel. 😔😔
I discovered this after several hours of frustration & vulgar language! 🤣🤣
All u need to do to find it is reach around the back of the console & feel for it & then push the tab slightly upwards until the panel that holds the cig lighter socket comes undone 😉
There is the antenna, and two other connectors behind the radio.
@@Tylerstoyotas thanks needed to kmow as im buying a wiring adaptor for my new stereo 😉😉
I have a 96 corolla how do you remove the rear deck speakers, I don’t want to break anything and CZcams doesn’t really show much about it...
Justin Woosley you need to remove the 3rd brake light, rear seat bottom, and rear seat back. If you have 60/40 folding seats you’ll need to remove the seat bottom, fold the seats down, remove the 2 side bolsters and the plastic trim. After all of that you can remove the rear dash panel to expose the speakers
If this video wasn't so old id ask if you wanted to sell me the old radio. I assume you trashed it though. :(
I can sell you mine
TheRed58Fury1 just get one from the local junkyard. This radio actually went into my sedan that I had at the time because I was selling it
Will an LED bulb work on the HVAC control and cigarette lighter?
Yes, provided that you buy the correct L.E.D.
what did you do with that old radio? Mine broke and i would like to replace it , don't mind using the old school one.
I put it in my old sedan before I sold it
Obrigado
No problem
what is the name of that dash bulb you mentioned? i think mine is blown need another 1?
I can't remember the part number, I'm sorry. But I got mine at work (toyota dealer) and the guy in parts knew exactly what bulb it was
Hey,
Do you know if there's much difference in this process for RHD corollas? I was unable to remove the plastic with the cigarette lighter and ashtray holder - it seems to be locked in somewhere.
To clarify, it popped out with a click kind of like yours in the video, but part of it still seems to be stuck.
Robert Griffith I checked with a friend of mine that has one in Australia and he said the process is the same. Like I said, some are pretty tough to get out
Very helpful!! Thank you!
no problem
Agree perfect video thank u
No problem
DIYCorolla Para que sirve el boton que tiene las tres flechas curviadas hacia arriba? responde rapido porfa
I don't speak spanish Miguel Cabrera
DIYCorolla For what is the button that has the three arrows curved upwards?
Miguel Cabrera it is the rear window defrost button
Thanks man.👍👍👍
Bomberito Juarez you’re welcome
O tienen tutorial del corolla93 en español..se les agradece..panama
you don't need to remove the bottom trim just the bolts and pull out the top trim
what is this "japanese stuff" you speak of? also is there an aftermarket door or something i can use to fill that ugly old storage bin?
there are all kinds of things that can go there. these are all just some of the things available in other countries though so they would have to be sourced and imported. there's the multibox, air fantasy, secret box, graphic equalizer, and a few other things that can be found. as for things you can use from the usa, you can use the storage compartment and cup holders from an 8th gen corolla that looks really good if done right. you can search the local junkyards for regular single din storage compartments. anything will work from like 1970 to 05 lol. if you'd like more info and some pictures just pm me and we will get in touch
You can fit in a double din screen or 2 single din(cd receiver & Dsp) like me 😛
what Japanese part did you put in?
TheRed58Fury1 multibox
@@Tylerstoyotas what is that
Is it possible to put a Double-Din Stereo in the lower section?
yes
+DIYCorolla Need an adapter/stereo wiring extension, available?
+Jim Farrell I'm pretty sure one is available
+DIYCorolla No way you can fit a double din when slot fits only din 1. Stop guessing.
Above radio has vents. Below radio has air vent selectors.
Again, not on a 1997 model for direct fit.
angelisone okay, first off, don't be an ass and use your head for a second. This CAN be done. You mound the double din where that large useless storage bin is above the cup holder. The radio wires reach there because that's actually where an upgraded tape deck mounts from the factory. Then, you go to the dealer and buy the delete plate that goes below the air vents because not all models came with radios. Know your shit before you comment.
Toyota exiv 1997 speed sensor location
upload more videos!!!!
i need the cup holder
You can get one from your local wreckers. Or, there are many to be purchased online
Спасибо теперь знаю)))
?
+DIYCorolla Thanks now I know how to remove the panel))
+Dimal Dima sweet!