Replacing the Volvo Blower Motor (with 5th Screw) but I make it `*~Artful~*`
Vložit
- čas přidán 7. 09. 2024
- I figured, what's a good way to make the old-fashioned blower motor replacement more fun? Practice the cinematic side of Cinemotive Garage. Thanks for checking it out! Trying very hard to be Chromatic Garage...
~More of the Volvo~
Episode 1 - Replacing the Serpentine Belt: • Replacing a Whistling ...
Episode 2 - Replacing the Blower Motor: (This One)
Help me support my high school classroom...
Subscribe: www.youtube.co...
Patreon (thanks XenoXX121!): / josh_white
Instagram: / ajoshwhite
Music by Dusty Decks
#VolvoV8 #XC90 #BlowerMotor
I love how the two most difficult screws to get out just magically are out and then back in when needed! (Said with tongue so far in cheek that it's hanging out my ear! )
You're probably having a worser time with this job than I had trying to get a camera and tools in the same spot while trying to lever the ducting to a point where I could access those screws. I don't envy you brother, good luck!
@@CinemotiveShopcraft TOTALLY understand!
Thats one nice volvo man!
Mine works, but vibrates the dash and steering wheel quite a bit at the two highest speeds...any suggestions ?
useful to se you do this. However my volvo 1) is right hand drive which means the 5th screw is very close to the left inner body panels. 2) is a D5 diesel and has another layer of insulating material (bitumen plus 3/4 inch sponge material) behind the thick felt plus sponge floor mat. It leaves no access to the 5th screw without cutting out this second layer of material. Understandable why people cut the plastic tab off with the screw.
50 cent a love these beats
What were your symptoms for having to replace the blower motor? On mine my rear AC is working fine, but the front vents are not putting out air. Almost nonexistent.
The blower wasn't sending air to the front vents - honestly, I can't remember if air was getting out the rear.
Why Video doesn’t show how you took off the last hard to reach screw hmm????ohh never mind you broke it like everyone else
Because it's hard to get the camera and tools and my eyes in the same spot while also applying pressure to the blower housing to move the screw into accessibility. Sorry to disappoint but good luck with this job!
Exactly this video is no help at all!! the trick is getting the screws back in care to leave us how you did it?
the screw is not needed
I don't like breaking OEM parts just to fit
Can't get the back screw out on an 09 so this vid was pointless for me except I had to listen to garbage music if you own an 09 get the four out and break the 5th off
Nice job. I am not looking forward to this.