Fixing Media Out Load Media Error on Zebra ZT420 or ZM400, 410,

Fixing Media Out Load Media Error on Zebra ZT420 or ZM400, 410,
Available on Amazon: amzn.to/2wB3ilu
In this video I show you what can trigger this and what seniors and stop points to check. Multiple Zebra printers get issues like this. Not just models listed here.

[@MaddogLIB]

This is a great fix if you don’t have anything wrong to fix. It’s like your car won’t start snd someone shows you how to put gas in it..... thanks for your help.

[@joesomenumbers]

Thanks for the video you saved a hospital during this covid surge

[@cryptocomputer-man6629]

It really made my day to know I helped bud. Thanks =)

[@neildymond2632]

Thanks, the sensor was not reading properly so it kept a continuous feed going, sorted now cos of your video

[@alfonsusdwiyoga]

Very Helpfull..thankyou bro

[@TheAlphaOmegaX3]

Thanks! Adjusted the laser and worked.

[@Bad_and_poujee]

Thank you...this is what I needed to know

[@EliteSithMaster]

Yep, seems it was the laser. Awesome help, thank you!

[@kyeongheum]

thank you so much! it solved my problem.

[@BenVanCamp]

You know that yellow clip that you nudged in to keep the paper in line? What if the paper keeps drifting under that clip and getting all out of whack? Had to twist up a paperclip and stick it through that hole.. Seems like really poor design, and I noticed they have a different clip design on the zt600's. Thoughts?

[@nimoo8266]

Many thanks bro!!

[@iamthelaw78]

Q: I have almost same ribbon printer as you, however i have problems with labels that print differently on ever other one. I use circular labels in which two of them side-by-side are being printed. If printed continuously, one set will print properly and other will print above its starting point. Do you know the cause of this and can help remedy this problem? Thanks, if you can answer this.

[@dcruz27]

Thanks!

[@shajibkhan9849]

Thank you so much

[@Firazfaris]

Great.thank you

[@cryptocomputer-man6629]

Glad I could help

[@johnlong765]

My laser is adjusted fine but still feeds one label and says media out

[@55baltimoreboy]

need to calibrate sensors

[@DanielRodriguez-vt6pf]

If the error message still appear after you finish this video. Make sure the you have the correct type of roll selected on the settings (Punched/Hole, Marked or Continuous). Follow video czcams.com/video/FiJnfNwBw8I/video.html