Video není dostupné.
Omlouváme se.
How To Ajust Bale Density On NewHolland BR7060 Baler
Vložit
- čas přidán 1. 08. 2024
- This video is about How To Ajust Bale Density On NewHolland BR7060 Round Baler. If you lookin to tighten you bales or increase the weight this how you ajust the pressure. Maybe you baler belts have some wear and strech in them and your pressure has decressed over time. This is how you ajust it.
Nice! Thanks i own a br740 and it's pretty much the same setup... never knew how to adjust density and my bales were kinda saggy a bit!! Big thumbs up budd!
Thanks glad it helped
Great video. Thanks!
You welcome
Does anyone know of any how to videos on ‘charging’ the bale density system after replacing the bale density gauge?
Cool video bro thx for sharing 👍 new friend here stopping by to show support let's grow together and stay connected
How did the bales turn out? How do you like your BR7060? I'm thinking about getting one
Much better they look great. I like it. It’s pretty much trouble free. It will also eat some big wind rows without balling up. I have a couple videos on it.
I wish my case had that kind of adjustment. I have to switch orifices
That sucks but I guess if you don’t change it very often it wouldn’t be so bad.
Good day, I have a new holland 654 press and it won't retract the mesh when making a bale
Not really familiar with the 654 Maybe an issue with the slicer? Did you check an make sure the actuator running the slicer is working?
@@4MRanch
I saw that it works when I push the grid a little. so I have to constantly get out of the tractor and push it in with each bale

Which way creates a denser bale? Higher pressure makes it denser or less dense?
Yes high pressure. I run at 1850
@@4MRanch thanks for the info. I think ours was around that last I checked. We are baling Bahia. It’s a new to me baler so I’m working through getting the pressure right and the timing right to auto tie. I have been having to do it manual so far but I think next cut I will have it all times and working good. Fingers crossed.
День добрый где можно найти инструкцию на пресс ньюхолланд 640
Цилиндр плотности тюка имеет регулировку предохранительного клапана. Более плотная настройка клапана = более высокое давление. Рекомендации по давлению приведены в руководстве оператора. Наиболее распространенной проблемой при длительном использовании или старых пресс-подборщиках является утечка через поршневые уплотнения цилиндра плотности или со временем в систему попадает воздух. Шаг 1 - зарядить гидравлическую систему плотности. Шаг 2 - повторно упаковать баллон для измерения плотности, если манометр заметно падает во время наматывания шпагата.
Прямо у основания цилиндра плотности находится большая черная ручка с фиксатором. Ослабьте фиксирующую планку, поверните ручку
это почти та же концепция, что и в видео