Dry Density of Soil by Core Cutter Method

Link for Water Content determination by Oven Dried Method
• Determination Of Water... This test is done to determine the in-situ dry density of soil by core cutter method as per IS: 2720 (Part XXIX) - 1975.The apparatus needed for this test is
i) Cylindrical core cutter
ii) Steel dolley
iii) Steel rammer
iv) Balance, with an accuracy of 1g
v) Straightedge
vi) Square metal tray - 300mm x 300mm x 40mm
vii) Trowel
Procedure Determine The In-Situ Dry Density Of Soil By Core Cutter Method
i) The internal volume (V) of the core cutter in cc should be calculated from its dimensions which should be measured to the nearest 0.25mm.
ii) The core cutter should be weighed to the nearest gram (W1).
A small area, approximately 30cm square of the soil layer to be tested should be exposed and levelled. The steel dolly should be placed on top of the cutter and the latter should be rammed down vertically into the soil layer until only about 15mm of the dolly protrudes above the surface, care being taken not to rock the cutter. The cutter should then be dug out of the surrounding soil, care being taken to allow some soil to project from the lower end of the cutter. The ends of the soil core should then be trimmed flat in level with the ends of the cutter by means of the straightedge.
iv) The cutter containing the soil core should be weighed to the nearest gram (W2).
v) The soil core should be removed from the cutter and a representative sample should be placed in an air-tight container and its water content (w)
A small area, approximately 30cm square of the soil layer to be tested should be exposed and levelled. The steel dolly should be placed on top of the cutter and the latter should be rammed down vertically into the soil layer until only about 15mm of the dolly protrudes above the surface, care being taken not to rock the cutter. The cutter should then be dug out of the surrounding soil, care being taken to allow some soil to project from the lower end of the cutter. The ends of the soil core should then be trimmed flat in level with the ends of the cutter by means of the straightedge.
iv) The cutter containing the soil core should be weighed to the nearest gram (W2).
v) The soil core should be removed from the cutter and a representative sample should be placed in an air-tight container and its water content (w)
REPORTING OF RESULTS
Bulk density of the soil g cc Y = [W2 - W1]/ V g/cc
Dry density of the soil g cc Yd = 100Y/[100+w] g/cc
Shop at 90sfashions
play.google.co...

[@jagannathdas7678]

Very useful video

[@dhananjayamohalik6957]

Thank you sir . Very good video

[@nandinidas2433]

Great video👍👍

[@rockyraul9562]

Conceptual video. ❤️❤️

[@pritishkumarpradhan3375]

nicely explained, now everything is clear sir

[@Jinxy397]

Nicely explained 👌👌🙏

[@civilengineeringinstitute4555]

Thank you sir