Bobcat left and right Joystick control calibration procedures

In this video I read off the calibration process for the left and right joystick controls for a bobcat skid steer with selectable joystick controls. I attribute my successes to god and give him the glory. Without him I would not survive.

[@alexissalas4171]

Excelente hermano bendiciones

[@HopesandDiesel]

Same procedure for a S300?

[@wendelafonso8822]

Quanto custa este manual?

[@eckoking8354]

How can I calibrate an actuator replacement I replaced an actuator but the controls for the tilt are backwards how can I fix that problem

[@JasonTheMunicipalMechanic]

I would try to re-pin the connector on the actuator and as far as the calibration process I don’t know off the top of my head but it should be in the video I believe I included both steps for both controllers in the video. You can probably disassemble the plug that goes into the actuator and swap the wiring around so that when you plug it in it’s its opposite so it works the correct way. I would verify though that you have the correct actuator in there before you did that.

[@rafaelsnep]

why this guy showing books , instead going inside one machine and show it live and easy process to people , we are at 2024.

[@JasonTheMunicipalMechanic]

Well…. I did it as a favor to the people that don’t have a repair manual. The information is not easy to find online so I thought I would supply it and maybe help somebody out. Better than nothing I guess.

[@rafaelsnep]

Not mention to offend, we just need make life easy.