International Harvester 444 Diesel Tractor Issues & Cold Start. Is it the Battery or the Alternator?
Vložit
- čas přidán 5. 09. 2024
- Hello and welcome to the channel! In this video, I dive deep into the world of tractor maintenance as I troubleshoot and address issues with my recently purchased International Harvester 444 Diesel Tractor. From tackling the charging system with a new battery and alternator, adjusting fan belt tension, frying my block heater, to performing a cold start, this video is a must-watch for tractor enthusiasts and DIYers alike.
If you found this video helpful, please give it a thumbs up, subscribe, and hit the notification bell for more tractor maintenance tips and tutorials. Feel free to leave any questions or comments below, and I'll do my best to help. Thanks for watching, and happy farming!
Website: www.CanadianIs...
Our Online Store: canadian-islan...
Facebook: / canadianislandlife
Interesting video Fred. Your perseverance in trouble shooting and repairing is a great asset to have in Canadian country living.👍👍
Thanks David, it's been a great learning experience!
Glad I found your channel. I have a 444 gas. allways wanted a loader on mine, instead I bought IH 606 with IH 2001 loader. I like my little 444 with its power steering very easy to handle. It has some bad leaks, front crank seal drips and a hyd leak. 3pt lift arms wont stay up so I had to use chains and turn buckels to set height for brush hog.
Glad you're having fun with it!
Cool tractor I forgot to say from Tucson Arizona
A problem I have found with single wire alt's is that they draw a slight current all the time. I used one but had to install a disconnect switch near the alt. It charged 13.8 which is ok,but would drain the batt over time. Takk
Interesting, thanks. I do install a disconnect switch on the neg battery terminal on all these old machines..
Hey I’ve got a 444 diesel and a 424 gas burner. Their both the same other than the engines. I’m curious as to which front end loader you have on yours? It looks like a 2050 but I would think it would be too heavy for a 444. I’m looking to find a good front end loader for mine also. I hope you can give me some insight, Sir
Hello, unfortunately I dont even know what the loader is. Only had it for about 4 months and the previous owner didn't know. Painted over a bunch of times but if I find out, I'll let you know!
Nice video. You should have measured the voltage directly on your alternator, some need a bit extra rpm to start the charging, and after that they charge on idle to. Might be cam angle, but to me it seems like the cable from the alternator is a bit on the thin side there. I have also a 444, i bought a tiny alternator whit internal fan, and relocated it to the left side of the engine, thereby using only 1 belt, and have a tensioner on the alternator, so i may use the tensioner on the water pump, and the new one on the alternator. It has 2 wires going to it, so i have a charging lamp to. New cable 6 square mm, and i have a happy life, newer problem whit the charging after that.
My glowplug`s broke, and whit the price for new ones, and how delicate they are, cant take any abuse at all, i bought glowplugs for a wv 1.6 liter and took out the original glowplug`s, drilled and tapped them for wv plugs, could not get the cone on the new plug to seal on the old ones, had to use red loctite to ceep them in, this is now 10 years ago. My tractor starts whit out problem in -20 Celsius whit out block heater.
IH 444 in my eyes is a nice old easy to maintain tractor, have had problems whit hydraulic twice, but its the filter in the hydraulic tank that gets clogged. You find it under your right foot as you sit in the seat. Drain the hydraulic tank, drain plug back on right side of tractor, loosen the hose clamps on the pipe going to the pump, located 30 cm from the tank against the pump, and pull the pipe going into the tank, its sealed whit a o-ring, then you get the filter out. Its brass mesh, so just clean it and reinsert it, fill the tank full whit hydraulic oil, and enjoy.
I run a snowblower on my tractor, don`t have a loader for it but it ceeps my drive way clean thru the winter.
Best regards from North East Norway
Thanks, someone else mentioned similar. I did check it at the alternator but it wasn't till after I had been blowing snow, that it started to charge more :)
The old girl sounds real good but 12.3 volts don’t sound like much
You're right. Latest video fixes that!
Isn’t there a exciter wire on the alternator or is there a external regulator
Good question. This is a single wire alternator with built in regulator so I don't think they have (or require) an exciter wire. Other issue was the old one sat for (I don't know how many years) and the bearings didn't sound too good. So I felt it was a candidate for replacement :)
@@CanadianIslandLife Hi , I own a 1965 B414 and I converted the non working generator to an 19:02 alternator that I converted to one wire . The internal regulator has the exciter circuit built in. I’ve been running it since 1992 with no issues. The only thing is that when running you have to accelerate the tractor initially to get the alternator to start charging at idle after that it will start producing charging current. Best upgrade I have done to the old girl!
Great, thanks for the explanation. So the trick is to make sure you're not always idling...@@robarcia2328
12.3 is not charging
Ya, tks. so like @v.t.d.g3052 mentioned earlier it has to spin at least 1400rpm before it will charge. Might not be the best type of alternator for a tractor as a lot of the time (unless using the pto) you're not usually at that high of an RPM. We'll see how it goes...
or use a smaller pulley @@CanadianIslandLife