7.3 idi race truck ep.13 fuel system upgrades
Vložit
- čas přidán 28. 04. 2023
- Hit like and subscribe for more idi videos. Until next week, check out these other #idi #6.9 #7.3 #diesel #bricknose #bullnose videos!
What to look out for when buying a used 6.9 or 7.3 idi diesel part 2
• Buying a 6.9 or 7.3 id...
What to look out for when buying a used 6.9 or 7.3 idi diesel part 1 • BUYING a Ford 6.9 or 7...
3g alternator upgrade in 6.9 or 7.3 idi diesel ford
• 3g alternator conversi...
7.3 idi engine wiring harness color codes and sensor locations
• 7.3 idi diesel wiring ...
The truth about idi injector return line kits
• The truth about inject...
Wiring you high idle to a manual switch.
• IDI diesel manual high...
Old timers trick injection pump repair in a bottle
• 6.9 7.3 idi diesel inj...
How to bleed air and prime a 6.9 or 7.3 idi diesel fuel system
• Bleeding air out of th...
Replacing power steering lines in my 6.9 idi
• 6.9 idi ford truck pow...
Idi coolant flush and refill
• 6.9 or 7.3 IDI diesel ...
Ford shower head fuel pick up to fuel sump
• Fuel sump install bull...
Ford fuel selector valve replaced with brass 3 way valves
• ford fuel tank selecto...
3g alternator swap to upgrade your old externally regulated alternator • Ford 7.3 idi diesel 1g...
Facet electronic lift pump installation
• 7.3 idi facet Duralift...
Where to plumb in and hook up aftermarket gauges to an idi engine (oil pressure, water temperature sender locations) • 7.3 idi diesel gauges ...
How to change 7.3 idi glow plugs • 7.3 idi diesel Ford e3...
7.3 idi race truck build part 1 tearing down the crash test dummy
• 7.3 idi diesel race tr...
7.3 idi manual glow plug button how to • 7.3 idi diesel glow pl...
7.3 idi fuel heater delete mod • 7.3 idi diesel ford fu...
High torque starter in a 6.9 or 7.3 idi diesel • Ford 6.9 idi diesel du...
Reviving a 6.9 idi diesel by hotwiring the fuel shut off solenoid and doing a manual glow plug button • 6.9 idi diesel crank n...
Basic wiring to hotwire and start a 6.9 idi from under the hood
• NO KEYS NO PROBLEM! Ho...
Basic wiring to hotwire and start a 7.3 idi from under the hood
• Start a 7.3 idi diesel...
Diagnose and test a heater defrost system that is not coming on
• Troubleshooting and re...
Heat only blows on high DO THIS!
• Heat only blows on hig...
Check out these videos for more information on my #wmo #blackdiesel centrifuge set up.
5 ways to save $ setting up a waste oil centrifuge
• Waste oil to black die...
5 hidden costs to setting up a centrifuge
• Waste oil to black die...
First batch of black diesel ran through my wvodesigns centrifuge
• waste oil to black die... - Auta a dopravní prostředky
Great job,👊🏼
Thank you! Cheers!
Tire recycling, complete! Good info on the fuel system for sure.
Thanks for watching! Hope you learned something from it.
Great video
Thanks! Glad you enjoyed it.
U R D man !!! Thanx 👍🤪
No problem, glad you enjoyed the video. Appreciate the comment.
GET’N HER DONE MY BOY!%
Thanks for watching.
Blow them tires off! Great video aspie.
Thanks!
On the 6.9 and 7.3 idi you can install up to a 9-11 psi lift pump that will increase fuel supply pressure and slightly increase injection timing (advance)
The pump I installed is 9-11.5 psiand 33gph. I have used it in several idi trucks with great results.
Dude I’m diggin your vibe! When is the diy propane injection?! 🤘
Thanks for watching, honestly never have looked into propane injection. Might read up and study a bit about it eventually.
Here's a fuel question of timing issue?
89 f450 starts only if sprayed a taste of it. Smokes like worse then slave lake. Hold throttle past 1/2 way. Truck shuts off. Starts back up if warm. Still same .
Stuff changed injection pump , glow plugs . Glow plugs on a button.
New o rings and return lines tank to engine. New lift pump.
Truck have excessive blow by and completely clapped out? If not, I would check timing next. Sounds like you have done most everything else. 2 other common issues would be fuel pick up shower head in the tank broke off tube rusted out. Or the tank switch valve leaking air or restricting fuel flow.
Changed that fuel sending unit . Engine has low miles it came out of a old grain truck.
I changed injection pump.
No Idea what previous owner did to it before I got it. Minimal blow by out of oil cap . If you let it idle for 20 minutes smoke goes away til you step on it but it shuts off still. I may just yank it and toss it. And put another 7.3 in it
I also drove it home 5 hours didn't smoke that bad. It had fuel oring leaks to start with but I drove it home. Then injection pump quit pumping fuel to injectors . But always started hard since I bought it.
@wrecker Jonny Make sure your fuel shut off solonoid is maintaining power. You could have gotten ip wiring backwards. Then start playing with timing or find someone that has the timing tools and can help you do timing.
Kinda sad to see an extra cab 4x4 not on the street when I have been looking for one in GA for bot a year. tons of 2wd, and even more single cabs, but 4x4 extra not so much.
This one was pretty clapped out when I got it. I definitely didn't start with a nice truck. But I do understand they are getting harder to find. Thanks for watching!
👍👍👍👍🇺🇸🇺🇸🇺🇸🇺🇸🙏🙏🙏🙏
Thanks for watching! Glad your a part of the chanel.
Hey, don't let any cop's get a hold of ur videos
I would hope they have enough discernment to go fight real crimes. Not waste time and resources on dumb shit. Leave a guy trying to produce entertaining content and get a few extra views alone... But...
Did I miss something? I thought this video was quite positive. Aspie you have made it now you officially have trolls! Keep up the good work and keep on building shit! Love your videos 👍
2.5 turns for your race truck...what do you recommend for a, light towing situations, 1989 F250 without having to worry too much about high EGTs? Cause these motors can be turds, i tell u what!