How to replace the rotary encoder on a car stereo - Healing bench 22
Vložit
- čas přidán 24. 12. 2021
- In this video, we will replace the rotary encoder on a car radio that was broken and it was jumping steps and jumping back to 0.
This is a relatively simple repair and it can be done by anyone with basic electronics knowledge and understanding.
Tools and materials used in the video:
JCD8898 Soldering station - s.click.aliexpress.com/e/_onZ...
Rotary encoder module - s.click.aliexpress.com/e/_A6Dr06
Low Melt Solder - s.click.aliexpress.com/e/_9fb8Xc
Wire snips - s.click.aliexpress.com/e/_Ao21Iq
Desoldering wick - s.click.aliexpress.com/e/_9ACmX4
Desoldering pump - s.click.aliexpress.com/e/_AbCHSO
Soldering helping hand - s.click.aliexpress.com/e/_9gyMA6
For full written instructions and step by step guide, visit the project Instructable over at:
www.instructables.com/How-to-...
Support my work on Patreon so I can continue producing free content and tutorials!
/ taste_the_code
My recording gear:
GT10 Pro 5G Android Phone - s.click.aliexpress.com/e/_oDn...
Dragon Touch 4K Action Camera - s.click.aliexpress.com/e/_mrc...
USB Condenser Microphone - s.click.aliexpress.com/e/_mq5...
Tripod - s.click.aliexpress.com/e/_ooa...
Phone tripod mount - s.click.aliexpress.com/e/_s9WaiJ
How to replace the rotary encoder on a car radio
#repair #carradio #rotaryencoder #healingbench #tastethecode
Main Site and blog: www.tastethecode.com
Facebook: / tastethecode
Instagram: / taste_the_code
Twitter: / taste_the_code
Get exclusive Taste The Code t-shirts and merch at
teespring.com/taste-the-code
Design great PCBs with Altium designer and get great discount!
aklam.io/vb3uTw
Click on the link below to get two months of free premium access to Skillshare and start learning today!
skl.sh/37LnRua
Get $50 off your order on hosting for all of your website needs and learning projects on Dreamhost!
www.dreamhost.com/r.cgi?24057...
Would a bit of flux and hot air gun not be easier? Just wondering. 👍🏻
Raboteeee!!! :)
My problem on the radio was that even tho when I pushed the button the function that regulates the tremors and bass worked, the tension function didn't go up. I replaced the button like you in the video and again the volume didn't go up-down, but again pushing it in was working to adjust the bass. What do you think is to blame? Can the line on the board be broken or made a mistake in gluing? Thank you very much in advance!
Hold your solder sucker over lead on back of board while holder soldering iron on same lead on front of board. When melted, trigger sucker.
whais the reference for the encoder you used please ? does t only roate 360 degrees ?
Is it possible to induce a 'push down' on the encoder remotely? ie. let's say that pushing-in the button mutes the stereo. Can I induce muting remotely? How would I go about doing this?
What is that blue tool you use