Custom order laser engraved Stanley Tumblers. Framing hack uniform large order tutorial

ournameshop.et...
/ engravethe801
/ engrave_the_801
tutorial on how to do large orders with uniform design in same location using Xtool F1 and creative space, how to clean tumbler after laser engrave, framing hack
#xtool #engravethe801 #ournameshop #etsyshop #etsy #businessowner #smallbusinessowner #customtumbler #personalizedgifts #businessmarketing #swag #xtoolf1 #tutorial #laserengraveutah #laserengraving #laserengravingbusiness #womenownedbusiness #3dprinting

[@nclay]

This is so helpful and thank you!

[@Engravethe801]

You're so welcome!

[@ashracampbell-clarke1887]

Are these powder coat?

[@tracyreinmiller6663]

If you run a second pass on the F1 using the IR laser at half the power of the Diode and leave the other settings the same, the IR laser will clean up the engrave leaving it nice and shiny without the need to use the magic eraser sponge which can dull the finish the cups.

[@Engravethe801]

Thank you for that tip! 😊 I’ll give it a go!

[@ronr179]

Great job 👏🏽. Can you share your settings for the S1? And what watt it is.

[@N8zwn]

Where do you get your Stanley cups? These turned out great. I am using the xtool S1 to do some tumblers.

[@Engravethe801]

My client purchased these Stanley’s from Sheels and I engraved each one for her.