How to make line Sensor array for LINE FOLLOWER ROBOT | JLCPCB
Vložit
- čas přidán 6. 07. 2024
- order your PCBs from JLCPCB
only $2 for 5pcs 1-4 layer PCBs; PCBA from $0
jlcpcb.com/ESC
in this video, I am showing how I made a line sensor array for a line follower robot
buy from here
www.esclabs.in/product/ir-lin...
circuit diagram
edisonsciencecorner.blogspot....
#electronics #robotics #diy
@EDISON_SCIENCE_CORNER
@JLCPCB - Věda a technologie
😍🤩
❤🎉
💎
So pin1 is output to LED on the upper side of the pcb and at the same time output to pin in JST-XH connector right?
and what is distance between each pair of sensor for best result?
Your diagram is a bit blurry.
The first pin is 5v the last pin is gnd. Middle pins are outputs. Please send me an email for the circuit diagram
@@EDISON_SCIENCE_CORNER Thank you for replying.
I already get that part. I mean pin 1 of LM358 is output to LED labeled "LED5 0805" and same output is connected to one of the middles pin in JST-XH. Is that correct?
Schematic please 😌
edisonsciencecorner.blogspot.com/2023/10/diy-line-sensor-array-for-line-follower.html
where is the schematic diagram
edisonsciencecorner.blogspot.com/2023/10/diy-line-sensor-array-for-line-follower.html
sir can you provide this gerber file?
No
@@EDISON_SCIENCE_CORNER i'm form other country, that's why i asked you..if you can provide it's will good, otherwise wise best wishes for you 😊😊😊
Can you give me the pcb for the line follower
I live in srilanka
And I commented on the line follower video
Yes