Thetis TX key up audio burst cause and cure.

Sdílet
Vložit
  • čas přidán 13. 09. 2024
  • IF you are experiencing this, try this out. At least for me at my station, this was the cause and cure. I hope this helps someone out there.

Komentáře • 10

  • @reallybadaim118
    @reallybadaim118 Před 3 měsíci +1

    Very nice setup.

  • @arthurgumbus3969
    @arthurgumbus3969 Před 3 měsíci +1

    Thanks for this cure.... Are you suggesting that all Thetis users set that delay? Was this phenomenon always present OR something new??

    • @KP68videogates
      @KP68videogates  Před 3 měsíci

      Hello sir. I noticed that only occasionally and I also noticed it when my AGC gain slider was set high (at or below the band noise floor) where I would be receiving a high amount of white noise while trying to talk to a distant station whos signal was mixed in with the noise floor. I didn't put 2 and 2 together until this weekend when it was bothering the crap out of me lol. Not all Thetis users may experience this because of the many ways receive audio can be routed. As far as if it was always present or not, I cannot be sure. There could be a setting in Thetis to mute the audio faster on key up but since the RF delay worked for me, I did not investigate the matter any further.

  • @MrNobody-gi3gj
    @MrNobody-gi3gj Před 3 měsíci +1

    thanks..... figured there was somewhere to re set the parameters for latency / delay.

    • @KP68videogates
      @KP68videogates  Před 3 měsíci +1

      Yes sir. Yet another thing great about Thetis is that if something isn't quite right for you or if something is seemingly awry, there is a high probability that there is a setting that can be changed or adjusted.