Revisiting the Anycubic Kobra Go Review || Best Budget Printer?
Vložit
- čas přidán 18. 07. 2023
- This video is a review on the Anycubic Kobra Go, is this the best budget printer to have come out in recent years? To really test this printer, I ran it through a ton of benchy prints to try and nail down the best settings for it, then I finally ran it through an All-in-one torture printing test, to really see what it is capable of. What is your opinion on this printer? Would you say that it deserves the crown for being the best, cheapest printer, or would you give that title to a different printer?
Kobra Go Assembly Video: • Installation and Level...
Product Link: 3dprintingstore.co.za/product...
#kobrago #printerreview #review #3dprinting #anycubic #3dprinter #filamentprinting #fdm #budgetprinters #cheap3dprinter - Jak na to + styl
Hi there! Were you ever able to get the Koibra Go to give you a "perfect" print - no banding or goofy anomalies?
so after you did the 20-25 point auto level did you have to do the Z Offset change as well or did this do both of those meshes itself?
From my experience, the z-offset was pretty much perfect after the 25 point levelling, but that could have just been coincidental, you install the proximity sensor onto the machine, if your proximity sensor is a little bit higher or lower than the nozzle, you would have to compensate that difference with the z-offset
good to know thank you!@@3DPrintingStorecoza
Can someone assist me with advice. Ender 3 Neo nozzle keeps going down to 20° instead of 200°
You can send us an email to support@3dprintingstore.co.za, or send us a whatsapp to 067 764 8256, one of our technicians may assist you with your issue
How does this printer compare to an ender 3? which is better?
I would say they are very similar, the Ender-3 Neo is a bit more consistent and has a more stable build (especially on the Z-axis lead screw).