Fantastic as usual master at work; however I have been told to put the collet into the collet nut before the tool as there is a groove that holds the collet in place I see you do not do this is there a reason why you dont do it?
@@nganaungcnc no on the collect nut there is a grove that locates the collect so it does not fall when you remove the tool hope this makes sense for you I will look for a link to help you
Watching your videos I feel free calling you an artist...thank you for sharing !
thank you!!
Awesome! You’re so very talented!
Thank you so much!
perfecto y genial tu video amigo
thank you!
Very nice!
Thank you!
Very beautiful watch. Congratulations on the job. What wood did you use?
thank ypu! i use wood (Yemane. White teak.)
Fantastic as usual master at work; however I have been told to put the collet into the collet nut before the tool as there is a groove that holds the collet in place I see you do not do this is there a reason why you dont do it?
do you mean how i dislodge end mill and tools? it is ER11 little bit strictly. i dislodge it
@@nganaungcnc no on the collect nut there is a grove that locates the collect so it does not fall when you remove the tool hope this makes sense for you I will look for a link to help you
Hey..amazing video.. just wanted to know what wood finish did you apply to the wood?
it is White teak(yemane)
@@nganaungcnc I mean to ask what did you apply with brush to the clock once it was done?
Quantas horas de usinagem. E qual software você usa? Mach3 ou Arduino
i think about 7-8 hour . i use mach3.
@@nganaungcnc comecei seguir seu canal. Top parabéns
thank you!
Switched off after eight minutes. Thought I was going to see some actual fabrication.
ok