Teakdeck Renovering

Fräsning av nåtspår

[@StemtoSternSailing]

Fantastisk smart metode. Godt jobbet. Mvh Jarle

[@gunterreull3254]

Ja

[@torstenbehrendt870]

Great job. How ddid you close the nail holes in the planks?

[@Amerona]

The nails was shot in the second caulk line and next in the third line. And so on. Therfore invissible.

[@torstenbehrendt870]

@@Amerona Makes sense, thanks.

[@StemtoSternSailing]

Smart utfør arbeid. Godt jobbet. Mvh Jarle

[@HyperionMV]

router to remove caulk or where you also deepening them channels? What kind of bit did you use and why multiple passes? Thanks.

[@Amerona]

I make the channels 4 -5 mm deep. I used a 4mm router bit. First pass 2,5mm deep. Second pass 4-6mm deep. Third pass 6mm deep with 0,5mm offset To get cleen edges. I looked for a 4,5mm router bit, but that was impossible to find.

[@adamropp8832]

Very helpful! What size nail? 18ga? 23ga pin?

[@Amerona]

Here in Sweden we are more metric😀 1,0x1,25 mm length depending on the thicknes of batten.

[@adamropp8832]

I have the same Makita Router: Where did you buy the base plate insert?

[@Amerona]

Two diferent baseplate come with the router. Baught in Sweden.

[@havnjero]

ser bra ut, men hvorfor ikke bruke spiker om igjen etter at du har sendte dem gjennom den veiledningsplanke?
asking for a friend ;)

[@Amerona]

Lite osäker vad du menar. Men spika gör man ju med ”dyckert-pistol”. Det är ju ”engångs-spik”. Plankan måste komma exakt rätt därför är det enklaste med tolken och sedan skjuta nya spikar.

[@havnjero]

om de ikke er for svake kunne du vel hamre dem til neste gang. tenkt ikke at de var for smale til det men kanskje de er.
kunne vel feste en avstand frå dekk til andre side av overfres.
inspirerande metode!

[@Amerona]

@@havnjero de är bara 0,8-1mm beroende på sort.