Install linear actuator on garden tractor
Vložit
- čas přidán 12. 09. 2024
- Linear actuator on tractor
How to install linear actuator
Linear actuator stopped working
Linear actuator on tractor
Garden tractor
#Gardetractor
#Repair
#Gardentractorfrontendloader
#Lawnmowerrepair
#DIY
#CarryAll
#CraftsmanMower
#Wheelhorsegardentractor
#JohnDeere
#mowerrepair
#smallenginerepair
#lawnandgarden
Linear actuators are great for adding a power lift to a tractor that does not have hydraulics. They are a bit slow but work really well. Great job fitting the replacement
This was less than $100 and will be a great asset
The big question is how long it will last
At that price point
Hey Lee , nice fix . I seen one the other day that was hydraulic . It was 12 volts and was all one unit . The only problem is , they are 289.00 !!
This was under $100- will see how long it last
Not a knock on your soldering by any means. However, industry standard is to tin the wire (straightened) with a little flux and solder, then lay the two tinned wires parallell and toich the sldering gun to them. They will stick immediately, and will transfer electricity efficiently.
The real key is to pre-tin your wires, and they will stick well and easily.
Hummmm- good to know
Thanks
Put the motor up to the top, that way water won't run down the shaft to the motor.
That’s a good suggestion, thanks
how did you keep from hitting the gas tank with the pieces that lift up and lower the arm's
I’m not looking at it right now, but it’s very close
Regardless how bad your solder joint looks, 3M black electrical tape will make it look better. You can stretch it pretty good to hide it 🙂
If I had tips would probably be better - ha
Eas looking forward to seeing you tear into the old one. Anyway, good vid.
I’ll do a vid on that this winter
Thanks for watching
Do they have any available on Amazon...my speedex has a bunch of shot hydraulics that are too far gone and need to modern upgrade it
I have a large selection on Amazon and actually this is where this came from
Thanks Lee!
Hey thanks for watching
who is the manufacturer of this, and where did you buy it
I got it off Amazon. It was like around $65 with a 4 inch stroke and I think the weight capacity was 650 pounds. I don’t remember the manufacturer right off.
It sat out in the weather a few times and actually I used it yesterday afternoon so it still works nicely, make sure when you get is waterproof as some of them or not