Push test on the power supply....laser should fire. If it does not...you may have an issue with the board inside the power supply. I see the fan is working but it may have nothing to do with the laser issue. May need a "newer" power supply....with a digital read out display. Fairly inexpensive
So the power supply was and wasn't broken, when I press the test button the laser works ok which suggests as per most comments that power supply ok but in my case it wasn't, I then open power supply and found a damage capacitor inside, hence replaced complete power supply.
Aoa brother I purchased new Tube some days Ago, yesterday I was running my laser machine but Unfortunately Its pipe lay down and All water fell when I saw All water fell machine was Working but I swutched off the machine and after fill the water in the cane I run my machine but now its not engraving. Plz indicate the problem and solve it If possible
Hi Rafal, replaced two things, power supply was looking ok but when I open the cover the capacitor inside was burned so replaced the complete power supply, secondly I have also replaced water switch of the laser, replacing these two items solved the issue. Hope you will resolve your soon.
@@palestineflipbook, I have had the same issue with burned resistor located just under the aluminium radiator. I swapped the PS before you post your comment! And it's okay so far. Thanks anyway!
Push test on the power supply....laser should fire. If it does not...you may have an issue with the board inside the power supply. I see the fan is working but it may have nothing to do with the laser issue. May need a "newer" power supply....with a digital read out display. Fairly inexpensive
So the power supply was and wasn't broken, when I press the test button the laser works ok which suggests as per most comments that power supply ok but in my case it wasn't, I then open power supply and found a damage capacitor inside, hence replaced complete power supply.
Main power supply of my laser machine heats up also the machine heats up . Do u know what is the fault ?
Aoa brother I purchased new Tube some days Ago, yesterday I was running my laser machine but Unfortunately Its pipe lay down and All water fell when I saw All water fell machine was Working but I swutched off the machine and after fill the water in the cane I run my machine but now its not engraving. Plz indicate the problem and solve it If possible
Hello Mohammed did you get this fix? If so what part you had to replace at the end?
Hi Rafal, replaced two things, power supply was looking ok but when I open the cover the capacitor inside was burned so replaced the complete power supply, secondly I have also replaced water switch of the laser, replacing these two items solved the issue. Hope you will resolve your soon.
@@palestineflipbook, I have had the same issue with burned resistor located just under the aluminium radiator. I swapped the PS before you post your comment! And it's okay so far. Thanks anyway!
@@palestineflipbook I think the water outlet of the laser tube should point upwards to get all the air out, at least on most tubes.
warum habe alle die röheren offen ein schlag und die ist kaput mach das doch mit alu profillen und akryl glas
Hi!
chutaya di v kheray