DIY Epoxy Flake Floor
Vložit
- čas přidán 6. 08. 2024
- Visit the blog post here engineeredtoslide.com/2022/03... Do you want to get started building your own motorsport fabrication skills? Check out my fabrication courses at engineeredtoslide.com/
- Auta a dopravní prostředky
Killer job on the shop floor! Cheers
Thanks mate, I am super happy with it.
Shops coming together beautifully 🤙
Shed tour vid 🙏🙏🙌🙌
More video with the cars ! 👌
looks good mate
Looks great!
How did you know I was about to do this in my garage?!
It's cool 🤘👍🔥
Hey nigel, great video. I just done my own garage with the same kit. Did you miss any spots with your clear coat? It's super hard to see when you are doing it?
How's it go if you drop a small fastener or screw etc on the floor, is it hard to find if you don't see it land?
Looks great. I'm tossing up between this or just straight base colour
It’s actually not too bad, running a satin coat over the top makes a huge difference to dropped bolts and the time spent looking for them. I guess it’s a toss up between a great looking floor that’s difficult to find bolts on, or a scratched dirty looking floor. For me the clean looking floor is a higher priority than getting down on my knees once a day.
@@Engineeredtoslide thanks Nigel. I'll keep it in mind.
Loving the channel too mate. Been following your builds ever since the GGT and DUT days mate. Great builds 👍
It looks like it's a pretty rough finish, any reason you didn't do a thicker clear coat to make it smooth?
I wanted a rough finish as a smooth finish would have been too slippery, I considered sanding and adding another coat but was advised against it as pushing cars would be a nightmare.
Не дай Бог потерять гайку на этом полу🤦♀️🤦♀️🤦♀️
Pretty sure you're not supposed to weld or torch/plasma cut over top of an epoxy floor, it'll burn and give off toxic fumes.
Thanks for the info, I don’t plasma cut on the floor and there’s only minimal spatter from my MIG gun so I’m not too worried about burning it.